Maytag MEDB700VQ Use and Care Guide - Page 12
Connect ground wire green or bare of direct wire cable to external ground conductor, screw. Tighten
UPC - 883049140483
View all Maytag MEDB700VQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
3. Connect ground wire (green or bare) of direct wire cable to external ground conductor screw. Tighten screw. A 3-wire connection: Power supply cord Use where local codes permit connecting cabinet-ground conductor to neutral wire. B C F A. External ground conductor screw B. Neutral ground wire C. Ground wire (green or bare) of power supply cord D. %" (1.9 cm) UL fisted strain refief £. Center silver-colored terminal block screw £ Neuu'a] wire (white or center wire) 4. Place the hooked ends of the other direct wire cable wires under the outer terminal block screws (hooks facing right). Squeeze hooked ends together. Tighten screws. !! !! C G F A. 3-wire receptacle (NEMA type lO-30R) B. 3-wire plug C. Neutral prong D. Spade terminals with upturned ends £. V4 " ( 1.9 cm) UL listed strain relief £ Ring terminals C. Neutra] wire (white or center wire) 1. I.oosen or remove center silver-colored terminal block screw. 2. Connect neutral wire (white or center wire) of power supply cord to the center, silvercolored terminal screw of the terminal block. Tighten screw. 5. Tighten strain relief screw. 6. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold- down screw. 7. You have completed your electrical connection. Now go to "Venting Requirements." A. External ground conductor screw B. Neutral ground wire C. Center silver-colored terminal block screw D. Neutral wire (white or center wire) £. V4" ( 1.9 cm) UL listed strain relief 12