Maytag MFI2266AEW Use and Care Guide - Page 11

UsingtheControls Initial Temperature Setting Temperatures are preset at the factory at 38 ° F (3° C) in the refrigerator compartment and 0 ° F (-18 ° C) in the freezer compartment. Adjusting the Control 24 hours after adding food, you may decide that one or both compartments should be colder or warmer. If so, adjust the control as indicated in the Temperature Control Guide below. • Do not change either control more than one degree at a time. Allow temperature to stabilize for 24 hours before making a new temperature adjustment. Temperature Refrigerator too cold Refrigerator too warm Freezer too cold Freezer too warm Turn refrigerator off Control Guide Set the refrigerator control to next higher number by pressing the (_ pad. Set the refrigerator control to next lower number by pressing the (_ pad. Set the freezer control to next higher number by pressing the _ pad. Set the freezer control to next lower number by pressing the _ pad. Press the freezer _ pad until "OFF" appears in the display. Press the (:_ in either the freezer or refrigerator section to turn back on. Water Reset Filter Status Indicator Light o,_ _ .... When a water filter has been installed in the (_,_ refrigerator, the yellow Order light will illuminate when the filter is 90% used OR 11 months have elapsed since the filter has been installed. The red Replace light will illuminate when the filter is 100% used OR 12 months have elapsed since the filter was installed. A new filter should be installed immediately when the Replace light is illuminated. After replacing the filter, press and hold the Reset Filter pad for three seconds. The Order and Replace lights will blink and then go off. Light Auto On o The Light feature can be used to provide light to the dispenser area. The light feature is automatically activated and the indicator light illuminates. There are two methods available for lighting the dispenser - Auto and Continous. The Auto light function activates the dispenser light at half-power when the light sensor detects that the light levels in the room are low. The Continuous light function provides light until deactivated. The On indicator light will illuminate. To Activate Auto Light: Press the Light pad once. The Auto indicator will illuminate. To Activate Continuous Light: Press Light pad again. The On indicator light will illuminate. To Deactivate Auto or Continuous Light: Press the Light pad a third time. This will turn off the dispenser and indicator light. Vacation Mode o The Vacation Mode feature causes the freezer ('v_o_ to defrost less frequently, conserving energy. The Vacation Mode indicator light will illuminate when the feature is activated. To activate, press the Vacation Mode pad. To deactivate, press the Vacation Mode pad again OR open either door. The indicator light will go off, and return to normal operating mode. 10