Maytag MFI2266AEW Use and Care Guide - Page 14

u,d Nuter

Get Maytag MFI2266AEW PDF manuals and user guides View all Maytag MFI2266AEW manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

Iceu,d Nuter Important: Do not remove ice storage bin without pressing ice maker switch to OFF. Removing ice storage bin while ON could result in ice falling into the ice storage bin enclosure, blocking the dispenser and disabling the bin from being locked into proper _osition. Note: Access to the ice storage bin will be limited with the left fresh food door opened at 90 degrees. Move cabinet forward to enable door to open sufficiently for ice storage bin access. To Install: Important: Ice bin must be locked in place for proper ice dispensing. If necessary, turn auger driver behind ice bin counterclockwise to properly align ice bin with auger driver. Press the switch ON to activate er Driver ice maker. Slide bin into guide rails located on either side of the enclosure. Push the ice bin in until resistance is felt. Raise the front slightly and push the ice bin completely in. An audible "click" is heard when the ice bin is located correctly. Operating Instructions • Confirm ice bin is in place. • After freezer section reaches between 0° to 2 ° F (-18 ° to -17 ° C), ice maker fills with water and begins operating. You will have a complete harvest of ice approximately every hour. • Allow approximately 3 to 6 hours after installation to receive first harvest of ice. • Discard ice created within the first 12 hours of operation to verify system is flushed of impurities. • Stop ice production by pressing the ON/OFF switch located on the front of the ice maker. The first one or two batches will probably contain undersized and irregular cubes because of air in the supply line. When the ice cubes are ejected it is normal for several cubes to be joined together at the ends. They can easily be broken apart. The ice maker will continue to make ice until the supply of ice cubes raises the ice maker arm, shutting the ice maker off. Certain sounds may accompany the various cycles of the ice maker. The motor may have a slight hum, the cubes will rattle as they fall into an empty storage bin and the water valve may click or "buzz" occasionally. • If the ice is not used frequently, the ice cubes will become cloudy, shrink, stick together and taste stale. Empty the ice storage bin periodically and wash it in lukewarm water. Be sure to dry the bin thoroughly before replacing it. • Beverages and foods should not be placed in the ice storage bin for quick chilling. These items can cause the ice maker to malfunction. • Press the switch on the ice maker front to OFF when the water supply is to be shut off for several hours. 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
Ice
u,d Nuter
Important:
Do not
remove
ice storage
bin without
pressing
ice maker switch
to OFF. Removing
ice
storage
bin while
ON could
result
in ice falling
into the
ice storage
bin enclosure,
blocking
the dispenser
and
disabling
the bin from
being
locked
into proper
_osition.
Note:
Access
to the ice storage
bin will
be limited
with
the left fresh
food door opened
at 90 degrees.
Move
cabinet
forward
to enable
door to open
sufficiently
for ice storage
bin access.
To Install:
Important:
Ice bin must
be
locked
in place for
proper
ice
dispensing.
If necessary,
turn
auger
driver
behind
ice bin
counterclockwise
to properly
align
ice bin with
auger
driver.
Press the switch
ON to activate
ice maker. Slide bin into guide
rails located
on either
side of the enclosure.
Push the ice bin in until
resistance
is felt. Raise the front
slightly
and push
the ice bin completely
in.
An
audible
"click"
is
heard
when
the
ice bin is located
correctly.
er
Driver
Operating
Instructions
• Confirm
ice bin is in place.
• After
freezer
section
reaches
between
0° to 2° F (-18 °
to -17 ° C), ice maker
fills with
water
and begins
operating.
You will
have a complete
harvest
of ice
approximately
every hour.
• Allow
approximately
3 to 6 hours after installation
to
receive
first
harvest
of ice.
•
Discard
ice created
within
the first
12 hours of
operation
to verify
system
is flushed
of impurities.
• Stop ice production
by pressing
the ON/OFF
switch
located
on the front
of the ice maker.
The first
one or two batches
will
probably
contain
undersized
and irregular
cubes
because
of air in the
supply
line.
When
the ice cubes
are ejected
it is normal
for
several
cubes to be joined
together
at the ends. They
can easily be broken
apart.
The ice maker will
continue
to make ice until
the supply
of ice cubes
raises the ice maker
arm, shutting
the ice maker
off.
Certain
sounds
may accompany
the various
cycles
of
the ice maker. The motor
may have a slight
hum, the
cubes
will
rattle as they fall into an empty
storage
bin
and the water
valve may click
or "buzz"
occasionally.
• If the ice is not used frequently,
the ice cubes will
become
cloudy, shrink,
stick
together
and taste stale.
Empty the ice storage
bin periodically
and wash
it in
lukewarm
water.
Be sure to dry the bin thoroughly
before
replacing
it.
• Beverages
and foods
should
not
be placed
in the
ice storage
bin for quick
chilling.
These
items can
cause the ice maker
to malfunction.
• Press the switch
on the ice maker
front
to OFF when
the water
supply
is to be shut
off for several
hours.
13