Maytag MHWZ400TQ Use and Care Guide - Page 11
Check, thetemperature, ofthewater, tomakesure, thathehotwater, isconnected, thehotwater, faucet, - and leaking
 |
UPC - 883049064338
View all Maytag MHWZ400TQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Chectkhetemperatuorfethewatetromakesurethathehotwatehr oseisconnectetod thehotwatefrauceatndthathecoldwatehr oseisconnectteodthecoldwatefraucet. Remove drain hose from washer drum 1. Use locking pliers, squeeze hose clamp tabs together and insert over the end of drain hose. Connect the inlet hoses to the washer IMPORTANT: Make sure that the flat washers have been placed into the hose couplings. 2. Slide drain hose onto washer connection. S C. Cok] water inlet H. Hot water inlet 1. Attach the hot water hose to the washer's hot (H) water inlet valve. Screw on coupling by hand until it is seated on the washer. 2. Attach the cold water hose to the washer's cold (C) water faucet. Screw on coupling by hand until it is seated on the washer. 3. Using pliers, tighten the couplings with an additional two-thirds turn. NOTE: Do not overtighten. Damage to the coupling can result. 4. Turn on the water faucets completely and check for leaks. NOTE: Replace inlet hoses after 5 years of use to reduce the risk of hose failure. Record hose installation or replacement dates on the hoses for future reference. Periodically inspect and replace hoses if bulges, kinks, cuts, wear, or leaks are found.
-
1 -
2
-
3
-
4
-
5
-
6 -
7 -
8 -
9 -
10 -
11 -
12 -
13 -
14 -
15 -
16 -
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27
-
28
-
29
-
30
-
31
-
32
-
33
-
34
-
35
-
36
-
37
-
38
-
39
-
40
-
41
-
42
-
43
-
44
-
45
-
46
-
47
-
48
-
49
-
50
-
51
-
52
-
53
-
54
-
55
-
56
-
57
-
58
-
59
-
60
-
61
-
62
-
63
-
64
 |
 |
