NEC PX-42VP1A 42PD1/50PD1 - Page 18
STANDBY/POWER lamp display, Notes
View all NEC PX-42VP1A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Power Management Function The power management function is an energy saving function that automatically reduces the power consumption of the display when the keyboard or the mouse have not been used for a fixed period. The power management function of the display becomes operational when the monitor is used with a personal computer based on the VESA DPMS and DVI DMPM system. When preparing to display a personal computer screen, check that the personal computer is properly connected to this unit and that the personal computer power is on. When the personal computer power is off, the power management function will be activated and this unit will be set to the off mode. For information about the power management setting method, see the operating system (OS) manual of the personal computer you are using. To see the video when the power management function is operating, setting the input selection to video will switch the function off. Power Management Modes There are three modes in the power management function. * Standby mode The standby mode is set when the horizontal sync signal from the personal computer is not input. The image will be displayed immediately upon the input of the horizontal sync signal. * Suspend mode The suspend mode is set when the vertical sync signal from the personal computer is not input. The image will be displayed about 4 seconds after the input of the vertical sync signal. * Off mode This unit is set to the off mode when the horizontal/vertical sync signals from the personal computer are not input. The image will be displayed about 4 seconds after the input of the horizontal/vertical sync signal. This is the only power management mode during RGB3 input. When there is no TMDS link, the off mode is set. (This power state is equivalent to the DPMS "off" state.) Displayed approximately 4 seconds after the TMDS link is restored. The color in which the STANDBY/POWER lamp lights indicates the mode (listed below) in which the unit is set. Mode Power ON * Standby * Suspend * OFF Power OFF STANDBY/POWER lamp display Green Yellow Orange Orange Orange Not lit Notes ---- Immediate return to normal display 15 W or less, returns to normal display in about 4 seconds Maximum 8 W or less, returns to normal display in about 4 seconds Remote control in standby mode Power cord not connected * Standby suspend, off in the table is the condition that exists when power management is ON. This is not the standby condition set by the remote control. 18