NEC PX-42VP1A 42PD1/50PD1 - Page 23

Adjustment of the Display (Direct) Press the buttons of the remote control to make direct adjustments and settings. A press of the desired button will show the adjustment display. The adjustment condition is stored in memory even after the power is switched off. Preparation: Select the input screen (VIDEO, RGB1, RGB2, RGB3) that is to be adjusted, then input the signal of the connected equipment. Adjustment of the Screen The adjustment of screen size is made easier when a geometric shape such as a square is displayed. Press the button to show the adjustment display. The display will go off about 3 seconds after your finger is released from the button. Adjustment of the screen display position Returning the Screen Adjustment to the Factory Default Settings (NORMAL) The display position (POSITION) will return to the factory default setting. At this time the following settings of the menu control will also simultaneously return to the factory default settings: auto picture, picture adjust, fine picture, H/V-POSITION 1, H/V-POSITION 2, H-WIDTH (Multiple Screens only), V-HEIGHT (Multiple Screens only), and OSM location. 1. Press the RASTER NORMAL button The verification sub menu is displayed. RASTER NORMAL WARNING ABOUT TO PRESET RASTER PRESS: 'PROCEED' TO RESET 'EXIT' TO CANCEL POSITION / CONTROL Move up Move left Move right Move down 2. A press of the PROCEED button will reset the adjustment. To cancel the reset, press the EXIT button. PROCEED Adjustment display of the up/down position V-POSITION wMOVE DOWN MOVE UP v Adjustment display of the left/right position H-POSITION ᮤ MOVE LEFT MOVE RIGHT ᮣ * Use the RASTER NORMAL button. A press of the VISUAL NORMAL button will not return the screen adjustment to the factory default setting. * A press of the NORMAL button during the on-screen display will return only the display item to the factory default setting. * H-POSITION 1,2 and V-POSITION 1,2 are not available at the time of RGB input when AUTO PICTURE is turned on. To adjust H-POSITION 1,2 and V-POSITION 1,2 at the time of RGB input, turn off AUTO PICTURE. 23