NEC VT695 NP115 : RS232 codes- Projectors - Page 29

037-4. LAMP INFORMATION REQUEST 3 Function: This command acquires the information on the projector lamp in Eco mode. Command: 03H 96H 00H 00H 02H DATA01 DATA02 CKS (*3) Data Portion Contents DATA01 Target 00H : Lamp1 01H : Lamp2 DATA02 item 00H : Lamp Hour Meter (second) (!) 01H : Lamp usage time (second) (!!) 04H : lamp remaining amount until lamp warning message (100% to -10%) 05H : Lamp counter (Normal mode) (second) (!!!) 06H : Lamp counter (Eco mode) (second) (!!!) 08H : Remaining time until lamp warning message starts to appear (in terms of specified values) 09H : Remaining time until lamp warning message starts to appear (in terms of Normal mode values) 0AH : Remaining time until lamp warning message starts to appear (in terms of Eco mode values) 10H : Remaining time until inhibition of lamp usage (in terms of specified values) 11H : Remaining time until inhibition of lamp usage (in terms of Normal mode values) 12H : Remaining time until inhibition of lamp usage (in terms of Eco mode values) Response: At the time of a success 23H 96H 01H xxH 06H DATA01 .. DATA06 CKS (*1) (*2) (*3) Data Portion Contents DATA01 same values as DATA01 of the command DATA02 same values as DATA02 of the command DATA03 .. 06 Acquired information Response: At the time of a failure A3H 96H 01H xxH 02H DATA01 DATA02 CKS (*1) (*2) (*4) (*3) Supplement: * In case of acquiring lamp's use of hours 03H 96H 00H 00H 02H 00H 01H 9CH Example of acquisition DATA03 DATA04 DATA05 DATA06: lamp's use of hours 50H 46H 00H 00H: 18000 seconds Calculator Procedure 1) Set calculator to HEX 2) Punch in DATA06 DATA05 DATA04 DATA03 (00004650) 3) Change from HEX to Decimal - value will change to 18000 seconds