NEC VT695 NP115 : RS232 codes- Projectors - Page 9

at the time of start 03H : The block number of transferred data is not consecutive. USB connection This conforms to the USB1.1 standard. Transfer speed: All speeds (supported) Endpoint: Control transfer Endpoint 0 Device class: HID class (Ver1.1) USB1.1 Standard: Universal Serial Bus Specification Revision 1.1 HID : Human Interface Device Connector Specifications 1 VBUS (Power supply) 2 D- (- Signal) 3 D+ (+ Signal) 4 GND (Ground) * Depending on the USB host controller in the personal computer, the USB connection may fail to operate. When using a USB hub, please use a self-powered type, not a bus-powered type. When using a USB hub, connection to the first stage of the USB hub is recommended. LAN connection Wired LAN port ] LAN interface Communication speed: Auto setting (10/100Mbps) Certified standard: IEEE802.3 (10BASE-T) IEEE802.3u (100BASE-TX, Auto-Negotiation) A LAN connector (8 male RJ-45 connector) 1 TD+ Transmit data (+) 2 TD- Transmit data (-) 3 RD+ Receive data (+) 4 Not used 5 Not used 6 RD- Receive data (-) 7 Not used 8 Not used [ Wired/wireless LAN card ] The LAN connections will differ depending on the commercial LAN card that is used. - For information on supported LAN cards, visit: Global: http://www.nec-pj.com/ [Port Number] The TCP port number used is "7142". 4. List of Commands