Netgear GS728TPP GS728TP/GS728TPP/GS752TP Hardware Installation Guide - Page 23
Step 4: Connect Devices to the Switch, Step 5: Install an SFP Transceiver Module
View all Netgear GS728TPP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
GS752TP, GS728TP, and GS728TPP Gigabit Smart Switch Step 4: Connect Devices to the Switch The following procedure describes how to connect computers to the switch's RJ-45 ports. The switch contains Auto Uplink technology, which allows the attaching of devices using either straight-through or crossover cables. Figure 11. Connecting devices to the switch Connect each computer to an RJ-45 network port on the switch front panel (Figure 11). Use a Category 5 (Cat 5) Unshielded twisted-pair (UTP) cable terminated with an RJ-45 connector to make these connections. Note: Ethernet specifications limit the cable length between the switch and the attached device to 100 meters (328 feet). Step 5: Install an SFP Transceiver Module The following procedure describes how to install an optional SFP transceiver module into one of the SFP ports of the switch. Note: Contact your NETGEAR sales office to buy these modules. If you do not want to install an SFP module, skip this procedure. 24