Netgear GS748Tv2 GS748Tv3 User Manual - Page 46
Enabling Jumbo Frames, Delete, Apply, Jumbo, Enable
View all Netgear GS748Tv2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Smart Switch Software User Manual GS748T Figure 4-18 To remove a multicast group: 1. In the line of the table that specifies the group, check the Delete box. 2. Click Apply to remove the group. Enabling Jumbo Frames Jumbo Frames are not an approved standard Ethernet frame size, so you must ensure that all of your networking equipment can support these nonstandard jumbo frames to prevent them from being dropped. The Jumbo Frame screen allows you to enable or disable jumbo frame support. The maximum default frame size is 1,518 bytes. When jumbo frame support is enabled, the frame size can vary from 64 bytes to 9,216 bytes. Jumbo frames is disabled by default. To configure a jumbo frame: 1. Select Switching > Switch Configuration from the main menu. The Jumbo Frame Configuration will display. 2. In the Jumbo Frame radio box, select Enable. 3. Click Apply. 4-16 v1.0, October 2007 Configuring the Switch