Netgear GS748Tv2 GS748Tv3 User Manual - Page 51

Ingress Control Mode, Apply

Get Netgear GS748Tv2 - Gigabit Smart Switch PDF manuals and user guides View all Netgear GS748Tv2 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 51 highlights

Smart Switch Software User Manual GS748T The Storm Control Settings table contains system-wide configuration parameters for storm control. To configure storm control: 1. Select Security > Traffic Control. The Storm Control screen will display. Figure 4-22 2. From the Ingress Control Mode pull-down menu, select the type of the packet storm: • Disable (to turn off storm control) • Unknown Unicast, Multicast and Broadcast • Multicast and Broadcast • Broadcast Only 3. In the Threshold field, specify the threshold rate limit (packets per seconds) for storm control. The valid range is from 1000 to 65535. 4. Click Apply. You must enable the Storm Control feature on each port individually from the Port Settings table. Storm Control is disabled on every port by default. To enable Storm Control: 1. Select Security > Traffic Control. The Storm Control screen will display. 2. Select the checkbox adjacent to the port that you want to change. Configuring the Switch v1.0, October 2007 4-21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
Smart Switch Software User Manual GS748T
Configuring the Switch
4-21
v1.0, October 2007
The Storm Control Settings table contains system-wide configuration parameters for storm
control.
To configure storm control:
1.
Select Security > Traffic Control. The Storm Control screen will display.
2.
From the
Ingress Control Mode
pull-down menu, select the type of the packet storm:
•
Disable (to turn off storm control)
•
Unknown Unicast, Multicast and Broadcast
•
Multicast and Broadcast
•
Broadcast Only
3.
In the Threshold field, specify the threshold rate limit (packets per seconds) for storm control.
The valid range is from 1000 to 65535.
4.
Click
Apply
.
You must enable the Storm Control feature on each port individually from the Port Settings table.
Storm Control is disabled on every port by default.
To enable Storm Control:
1.
Select Security > Traffic Control. The Storm Control screen will display.
2.
Select the checkbox adjacent to the port that you want to change.
Figure 4-22