Netgear GS752TP GS728TP/GS728TPP/GS752TP Hardware Installation Guide - Page 23

Step 4: Connect Devices to the Switch, Step 5: Install an SFP Transceiver Module

Get Netgear GS752TP PDF manuals and user guides View all Netgear GS752TP manuals
Add to My Manuals
Save this manual to your list of manuals

Page 23 highlights

GS752TP, GS728TP, and GS728TPP Gigabit Smart Switch Step 4: Connect Devices to the Switch The following procedure describes how to connect computers to the switch's RJ-45 ports. The switch contains Auto Uplink technology, which allows the attaching of devices using either straight-through or crossover cables. Figure 11. Connecting devices to the switch Connect each computer to an RJ-45 network port on the switch front panel (Figure 11). Use a Category 5 (Cat 5) Unshielded twisted-pair (UTP) cable terminated with an RJ-45 connector to make these connections. Note: Ethernet specifications limit the cable length between the switch and the attached device to 100 meters (328 feet). Step 5: Install an SFP Transceiver Module The following procedure describes how to install an optional SFP transceiver module into one of the SFP ports of the switch. Note: Contact your NETGEAR sales office to buy these modules. If you do not want to install an SFP module, skip this procedure. 24

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
24
GS752TP, GS728TP, and GS728TPP Gigabit Smart Switch
Step 4: Connect Devices to the Switch
The following procedure describes how to connect computers to the switch’s RJ-45 ports.
The switch contains Auto Uplink technology, which allows the attaching of devices using
either straight-through or crossover cables.
Figure 11. Connecting devices to the switch
Connect each computer to an RJ-45 network port on the switch front panel (
Figure
11
). Use a
Category 5 (Cat 5) Unshielded twisted-pair (UTP) cable terminated with an RJ-45 connector
to make these connections.
Note:
Ethernet specifications limit the cable length between the switch and
the attached device to 100 meters (328 feet).
Step 5: Install an SFP Transceiver Module
The following procedure describes how to install an optional SFP transceiver module into one
of the SFP ports of the switch.
Note:
Contact your NETGEAR sales office to buy these modules. If you do
not want to install an SFP module, skip this procedure.