Netgear M5300-28GF3 Web Management User Guide - Page 225
RIP, Basic, Routing, RIP Configuration, RIP Admin Mode, APPLY, CANCEL
View all Netgear M5300-28GF3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 225 highlights
ProSafe M5300 Switch RIP Note: RIP is a licensed feature and is available only on switches that have an active license installed. RIP is an Interior Gateway Protocol (IGP) based on the Bellman-Ford algorithm and targeted at smaller networks (network diameter no greater than 15 hops). The routing information is propagated in RIP update packets that are sent out both periodically and in the event of a network topology change. On receipt of a RIP update, depending on whether the specified route exists or does not exist in the route table, the router may modify, delete, or add the route to its route table. From the RIP link, you can access the following pages: • Basic on page 225 • Advanced on page 226 Basic From the Basic link, you can access the following pages: • RIP Configuration (Basic) on page 225 RIP Configuration (Basic) Use the RIP Configuration page to enable and configure or disable RIP in Global mode. To display the RIP Configuration page, click Routing RIP Basic RIP Configuration. To configure the administrative mode of ARP on the switch: 1. Use the RIP Admin Mode field and select Disable or Enable. 2. Click APPLY to update the switch with the change. 3. Click CANCEL to abandon the change. Routing 225