Netgear RN51661E Software Manual - Page 33

ReadyNAS OS 6.1 Table 2. X-RAID2 vertical expansion requirements RAID Level Disk Replacements Required for Vertical Expansion RAID 1 Replace 2 or more disks with larger-capacity disks. RAID 5 Replace 2 or more disks with larger-capacity disks. RAID 6 Replace 4 or more disks with larger-capacity disks. If you replace fewer disks than required for vertical expansion, the disks are reserved for data protection. Your available storage capacity does not increase to accommodate the reserved disks until you replace the required number of disks. IMPORTANT: To reduce the risk of data loss, NETGEAR recommends that you back up your data before vertically expanding a volume.  To vertically expand an X-RAID2 volume: 1. Replace one disk in the volume with a larger-capacity disk. For more information about how to add a disk to your system, see the hardware manual for your system, which is available at http://support.netgear.com/product/ReadyNAS-OS6. Note: You must use supported disks in your ReadyNAS system. For a list of supported disks, visit http://www.netgear.com/readynas-hcl. 2. Wait for the volume to resync your data. You can continue to use your ReadyNAS system while the volume is resyncing. Resyncing can take several hours. The start and completion of the resyncing process is recorded in the system log (see System Logs on page 219). If you set up email notifications for your system, you receive an email message when the process finishes. For more information about alert notifications, see Configure System Alerts on page 169. 3. Repeat Step 1-Step 2 until you have replaced the required number of disks with larger-capacity disks. For more information about X-RAID2 vertical expansion requirements, see Table 2 on page 33.  To vertically expand a Flex-RAID volume: 1. Replace one disk in the volume with a larger-capacity disk. Volume Configuration 33