Netgear WGE101 WGE101 Reference Manual - Page 19

Setting the Bridge, s Data Rate - 802 11g

Get Netgear WGE101 - 802.11g Wireless Ethernet Bridge PDF manuals and user guides
UPC - 606449029567
View all Netgear WGE101 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 19 highlights

Setting the Bridge's Data Rate The wireless Ethernet standard, 802.11, supports several data rates - the most common are the 802.11b and the 802.11g standards. The 802.11b standard is slower with a maximum data rate of 11 Mbps. The 802.11g standard supports data rates up to 54 Mbps. By default the WGE101 bridge is set to connect at either standard, but it tries first using the 802.11g standard. If you want to force the bridge to connect using a specific standard, you can set the Data Rate on the Wireless Settings page. Note: The actual data rates achieved can be much lower than the maximum depending on the devices, distances, and any interference. 1. Start your browser software. 2. Type http:// followed by the IP address for the bridge as the web address and press Enter (or Return). Note: The default value is 192.168.0.201. If you've set the bridge to use DHCP, check the router table to find out what the current address is for the bridge. 3. Type admin as the User ID and type the current password. (password is the default.) 4. Click OK. You'll see the Status page. 5. Click Wireless Settings. 6. Select either B only (802.11b) or G only (802.11g) as the Data Rate. 7. Click Apply. 8. If you are through making changes, click Logout. 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
Setting the Bridge
’
s Data Rate
The wireless Ethernet standard, 802.11, supports several data rates
—
the most common are
the 802.11b and the 802.11g standards. The 802.11b standard is slower with a maximum data
rate of 11 Mbps. The 802.11g standard supports data rates up to 54 Mbps. By default the
WGE101 bridge is set to connect at either standard, but it tries first using the 802.11g
standard. If you want to force the bridge to connect using a specific standard, you can set the
Data Rate on the Wireless Settings page.
Note:
The actual data rates achieved can be much lower than the maximum depending on the
devices, distances, and any interference.
1.
Start your browser software.
2.
Type
http://
followed by the IP address for the bridge as the web address and press
Enter
(or
Return
).
Note:
The default value is
192.168.0.201
. If you
’
ve set the bridge to use DHCP, check the
router table to find out what the current address is for the bridge.
3.
Type
admin
as the User ID and
type the current password.
(
password
is the default.)
4.
Click
OK
.
You
’
ll see the Status page.
5.
Click
Wireless Settings
.
6.
Select either
B only
(802.11b) or
G only
(802.11g) as the Data Rate.
7.
Click
Apply
.
8.
If you are through making changes,
click
Logout
.
17