Netgear WGE101 WGE101 Reference Manual - Page 6

2 Installing the WGE101 Bridge family Internet room NETGEAR Cable/DSL 3 modem WGR814 54 Mbps Cable/DSL Wireless Router Desktop PC with Ethernet connection Macintosh computer with WGE101 54 Mbps Wireless Ethernet Bridge Gaming console with WGE101 54 Mbps Wireless Ethernet Bridge This section provides instructions for connecting the WGE101 54 Mbps Wireless Ethernet Bridge, using the default settings, to either a single Ethernet-enabled device or to multiple devices through a switch or hub. Note: If you find that the default settings don't work, if you know that you've configured your wireless network with WEP security, if you're placing more than one WGE101 bridge on the network, or if you are not in the United States, you'll have to configure the bridge before connecting it to the Ethernet-enabled device(s). To configure the bridge, see Configuring the WGE101 Bridge for Your Wireless Network on page 12. Connecting the Bridge to a Single Device 1. Unpack the box and verify the contents. 2. Identify a flat surface where you will put the wireless bridge. For best results, follow these guidelines: • Place it away from potential sources of interference, such as computers, monitors, TVs, microwaves, cordless phones, or large metal surfaces. Warning: Failure to follow these guidelines can cause intermittent or complete failure of wireless connectivity. • Place it in an elevated location such as a high shelf or on a wall in the center of your wireless access area. If you mount the bridge on a wall, do not place the bridge in such a way that it is vertical with the NETGEAR name upside-down and the power adapter plug hanging from the bottom of the unit. Having the unit in this position violates power adapter regulations. 3. Lift the bridge's antenna so it is vertical. 4