Nikon 9282 User Manual - Page 13

Get to Know Your Scanner En Your Scanner ³ 4000 ED/COOLSCAN IV ED ¿ Front View · »´ ¶ 4000 ED Rear View ² º ¾ COOLSCAN IV ED ³ Status LED This LED blinks slowly (roughly twice every three seconds) when the scanner is in operation. Do not turn the scanner off, remove or insert adapters, or eject or insert film until the LED has stopped blinking and is glowing steadily. If the LED flashes rapidly (about five times a second), a communications error has occurred or there is a problem with the scanner. Turn the scanner off, wait for at least five seconds, and then turn it back on. · Adapter slot This is where you put adapters for different types of film. Don't put anything in this slot except an approved Nikon film adapter. » Sliding cover Slide the cover down before inserting a film adapter. To protect your scanner from dust and other foreign objects, be sure ALWAYS to close the cover when no adapter is in place. ¿ Power switch Press this switch to turn the scanner on and off. ´ Film gate for optional SA-30 roll-film adapter (4000 ED) Open this gate only when you are using the SA-30 roll-film adapter (available separately). ² AC connector Connect the female end of the power cable here. ¶ IEEE 1394/Firewire interface connector (4000 ED) Connect the IEEE 1394/Firewire interface cable here. º Feet Always place the scanner on one of its two sets of feet. ¾ USB interface connector (COOLSCAN IV ED) Connect the USB interface cable here. 3