Nikon COOLPIX W300 Reference Manual complete instructions - English - Page 11

Before Using the Camera Underwater, Notes About Operating Temperature, Humidity, and Condensation - memory card

Page 11 highlights

Before Using the Camera Underwater Check the items below before using the camera underwater. • Remove the camera strap for land use. • Make sure that there are no foreign substances inside the battery-chamber/ memory card slot cover. • Make sure that the waterproof packing of the battery-chamber/memory card slot cover is not cracked or deformed. - Make sure that the waterproof packing is not detached from the camera. • Make sure that the battery-chamber/memory card slot cover is firmly closed. - Make sure that the latch indicator indicates the "Close" status. Notes About Operating Temperature, Humidity, and Condensation The operation of this camera has been tested at temperatures from -10°C to +40°C (14°F to 104°F). When you use the camera in cold climate regions or at high altitudes, observe the following precautions. • Battery performance deteriorates temporarily when cold. Keep the camera and batteries warm under your clothing before use. • Camera performance may deteriorate temporarily if it is exposed to extreme cold for an extended period. For example, the monitor may appear darker than normal immediately after the camera is turned on, or residual images may be produced. ● Environmental conditions that are likely to cause condensation Fogging (condensation) may occur on the inside of the monitor or lens when there are sharp temperature changes or high humidity, such as in the environmental conditions described below. This is not a camera malfunction or defect. • The camera is suddenly immersed in cold water after being in a hot place on land. • The camera is brought to a warm place such as inside a building after being in the cold outdoors. • The battery-chamber/memory card slot cover is opened or closed in a high- humidity environment. ● Reducing condensation • Open the battery-chamber/memory card slot cover, put the camera and a commercially- available desiccant in a container such as a plastic bag, and seal the container. Condensation is less likely to occur if the humidity inside the camera is reduced. • Before using the camera underwater, avoid storing it in locations where the camera may become hot (such as under direct sunlight). If you submerge the camera underwater while it is hot, the sudden change in temperature may cause condensation. xi Introduction Notes About Shockproof, Waterproof, and Dustproof Performance and Condensation

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176
  • 177
  • 178
  • 179
  • 180
  • 181
  • 182
  • 183
  • 184
  • 185
  • 186
  • 187
  • 188
  • 189
  • 190
  • 191
  • 192
  • 193
  • 194
  • 195
  • 196
  • 197
  • 198
  • 199
  • 200
  • 201
  • 202
  • 203
  • 204
  • 205
  • 206
  • 207
  • 208
  • 209
  • 210
  • 211
  • 212
  • 213
  • 214
  • 215
  • 216
  • 217
  • 218
  • 219
  • 220
  • 221
  • 222
  • 223
  • 224
  • 225
  • 226
  • 227
  • 228
  • 229
  • 230
  • 231
  • 232
  • 233
  • 234
  • 235
  • 236
  • 237
  • 238
  • 239
  • 240
  • 241
  • 242
  • 243
  • 244
  • 245
  • 246

xi
Introduction
<Important> Notes About Shockproof, Waterproof, and Dustproof
Performance and Condensation
Before Using the Camera Underwater
Check the items below before using the camera underwater.
Remove the camera strap for land use.
Make sure that there are no foreign substances inside the battery-chamber/
memory card slot cover.
Make sure that the waterproof packing of the battery-chamber/memory card slot
cover is not cracked or deformed.
-
Make sure that the waterproof packing is not detached from the camera.
Make sure that the battery-chamber/memory card slot cover is firmly closed.
-
Make sure that the latch indicator indicates the “Close” status.
Notes About Operating Temperature, Humidity, and
Condensation
The operation of this camera has been tested at temperatures from –10°C to +40°C
(14°F to 104°F).
When you use the camera in cold climate regions or at high altitudes, observe the
following precautions.
Battery performance deteriorates temporarily when cold. Keep the camera and
batteries warm under your clothing before use.
Camera performance may deteriorate temporarily if it is exposed to extreme cold
for an extended period. For example, the monitor may appear darker than normal
immediately after the camera is turned on, or residual images may be produced.
Environmental conditions that are likely to cause condensation
Fogging (condensation) may occur on the inside of the monitor or lens when there
are sharp temperature changes or high humidity, such as in the environmental
conditions described below. This is not a camera malfunction or defect.
The camera is suddenly immersed in cold water after being in a hot place on land.
The camera is brought to a warm place such as inside a building after being in the
cold outdoors.
The battery-chamber/memory card slot cover is opened or closed in a high-
humidity environment.
Reducing condensation
Open the battery-chamber/memory card slot cover, put the camera and a commercially-
available desiccant in a container such as a plastic bag, and seal the container.
Condensation is less likely to occur if the humidity inside the camera is reduced.
Before using the camera underwater, avoid storing it in locations where the camera
may become hot (such as under direct sunlight).
If you submerge the camera underwater while it is hot, the sudden change in
temperature may cause condensation.