Nikon R1C1 Wireless Close-Up Speedlight System Users Manual - English - Page 31
Attaching the SB-R200 to the front of the lens.
View all Nikon R1C1 Wireless Close-Up Speedlight System manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
z Flash operation using the R1C1 4 Attaching the SB-R200 to the front of the lens. 1 Attach one of the Adapter Rings to the front of the lens. Five types of Adapter Rings with different diameters (ø52mm, ø62mm, ø67mm, ø72mm, and ø77mm) are provided. • Turn the Adapter Ring securely until it stops. • These rings cannot be used together with other lens filters. • AF Micro-Nikkor 105mm f/2.8D is shown in the illustration. 2 Press the Attachment Ring SX-1's Mounting Buttons on both sides to attach it to the Adapter Ring, then release. • Make sure that the Nikon logo (p. 24) on the SX-1 is on the under side facing down. • Use fingers of both hands to press the two Mounting Buttons on both sides to attach the SX-1 securely. • Make sure that the SX-1 is not attached at an angle. If it is, remove and reattach. 3 Slide the SB-R200's Mounting Foot into the SX-1's Mounting Groove, then slide the lock switch. The Mounting Foot cannot be inserted in reverse. • Slide the lock switch until it stops and make sure that the red part can no longer be seen. 4 Move the SB-R200 slowly by holding down the Release Button on the SB-R200's Mounting Foot. Remove your fingers at the desired position to secure it. There are click stops every 15° on the Attachment Ring. 31 LOCK LOCK