Nikon SB-26 Instruction Manual - Page 25

F4-Series F-801/N8008 and F-801s/N8008s SB-26 10 Confirm shooting distance. Check whether subject falls within the range shown by the shooting distance indicator bars / in the SB-26's LCD panel. If not, move closer to subject or select a wider aperture (in aperture-priority auto or manual exposure mode), then repeat steps 9 and 10. 11 Confirm ready-light has come on and subject is in focus. Confirm ready-light is on in the camera's viewfinder g or on the SB-26 Â. Check whether subject is in focus by using the in-focus indicator ! in the camera's viewfinder. Firing Flash Chapter 3 TTL Auto Flash H Mode: For F4-Series, F-801/N8008 and F-801s/N8008s Users 12 Fully depress the shutter release button to fire flash. 13 Check again whether ready-light is blinking. If ready-light blinks for a few seconds after shooting, flash has fired at its maximum output but the light may have been insufficient. Reconfirm shooting distance and, if necessary, move closer to subject or select a wider aperture (in aperture-priority auto or manual exposure mode) to compensate underexposure. Controlled shutter speed and aperture in Matrix Balanced Fill-Flash/Standard TTL Flash When the SB-26 is set at q position (for flash sync mode selector), the camera automatically controls the shutter speed and aperture between 30 - 1/250 sec. in programmed auto and aperture-priority auto exposure mode. 48 49