Nikon SB-26 Instruction Manual - Page 44

Set Up and Practice 2 Flash sync mode selector at NORMAL 3 ISO film speed in use and zoom-head position 86 1 Flash mode selector at Manual Flash 6 Aperture value 4 Flash out- put level 1 Choose i position (flash mode selector). Confirm D appears in the LCD panel. 2 Choose W position (flash sync mode selector*). * q position is used for Rear-Curtain Sync Flash, and only with the F5, F90X/N90s, F90-Series/N90, F70-Series/N70, F4-Series, F-801/N8008, and F-801s/N8008s. For details, see page105. 3 Set ISO film speed and the built-in zoom head position. For instructions, see "Setting ISO Film Speed (Manual Adjustment)," pages 27 to 28, and "Setting Zoom-Head Position (Manual Adjustment)," pages 29 to 30. Automatic ISO film speed/zoom-head position adjustment: F5, F90X/N90s, F90-Series/N90, F70-Series/N70, F4-Series, F-801/ N8008, or F-801s/ N8008s used with an AF Nikkor lens (including the latest D-Type) or Nikkor lens having a built-in CPU The film speed and zoom-head position in use are automatically set and indicated in the SB-26's LCD panel. For other lenses, set manually according to the shooting situation. See "Setting ISO Film Speed (Manual Adjustment)," pages 27 to 28, and "Setting Zoom-Head Position (Manual Adjustment)," pages 29 to 30. Chapter 3 Manual Flash i Mode 4 Press ı button to choose desired light output. You can choose an amount ranging from full power (1/1) to one sixty-fourth (1/64). LCD indications change as: - h ' - " - j - k - l - ;-. With the F5, F90X/N90s, F90-Series/N90 and F70Series/N70, indication 1, and then 2 will appear after ;. At the same time, F appears next to D. This applies exclusively to FP High-Speed Sync Flash and is discussed in the following pages (see pages 98 to 103). Fine light-output adjustment: F5, F90X/N90s, F90Series/N90 and F70-Series/N70 with AF Nikkor lens (including the latest D-Type) or Nikkor lens having a built-in CPU Additionally, you can manipulate light output in finer increments of ±1/3, as long as light output is set between ' and ;. Press ◊ button and confirm L appears in the SB-26's LCD panel. By pressing ˛ button, you can increase the light amount by +1/3 (blinking +0.3 below the L mark), by +2/3 (blinking +0.7), or by +1 (blinking 0.0). To decrease, use Ç in the same manner; blinking numbers change from _0.3 (by -1/3) to _0.7 (by -2/3) to 0.0 (by -1). *At ', you cannot increase the light amount. 87