Nokia NBB5005000 Installation Guide - Page 25

Performing the Initial Hardware Configuration

Get Nokia NBB5005000 - IP VPN 5i PDF manuals and user guides View all Nokia NBB5005000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 25 highlights

Performing the Initial Hardware Configuration To reset the Nokia 5i and Nokia 10i to factory defaults 1. Remove power. 2. Press the Reset switch. Use a large flat-tipped object, such as a thick paper clip, to press the reset switch. Do not use a sharp pin or thin piece of metal to press the reset button. 3. Apply power and keep the switch pressed until the "wait after 0" message appears on the console port. The kernel boots and starts the configuration wizard. For the front panel descriptions, see "System Status LEDs" on page 31. Performing the Initial Hardware Configuration The first time you turn on power to a Nokia 5i or Nokia 10i gateway, the initial hardware configuration process begins. This section describes how to perform the initial configuration manually by using a console connection. It includes the following sections: „ Connecting the Console Port „ Connecting Power and Turning the Power On Note Nokia recommends that you install all hardware components before you perform the initial hardware configuration. Nokia 5i and 10i Installation Guide 25

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
Performing the Initial Hardware Configuration
Nokia 5i and 10i
Installation Guide
25
To reset the Nokia 5i and Nokia 10i to factory defaults
1.
Remove power.
2.
Press the Reset switch.
Use a large flat-tipped object, such as a thick paper clip, to press the reset
switch.
Do not use a sharp pin or thin piece of metal to press the reset
button.
3.
Apply power and keep the switch pressed until the “wait after 0” message
appears on the console port.
The kernel boots and starts the configuration wizard.
For the front panel descriptions, see
“System Status LEDs”
on page 31.
Performing the Initial Hardware Configuration
The first time you turn on power to a Nokia 5i or Nokia 10i gateway, the
initial hardware configuration process begins.
This section describes how to perform the initial configuration manually by
using a console connection. It includes the following sections:
Connecting the Console Port
Connecting Power and Turning the Power On
Note
Nokia recommends that you install all hardware components before you
perform the initial hardware configuration.