NordicTrack Cx 1055 Elliptical Exerciser English Manual - Page 21

Maintenance And Troubleshooting

Page 21 highlights

MAINTENANCE AND TROUBLESHOOTING Inspect and properly tighten all parts of the elliptical exerciser regularly. Replace any worn parts immediately. For smooth operation of the elliptical exer- ciser, inspect and clean the incline ramp regularly using a soft cloth and Incline Ramp mild detergent. Other parts of the elliptical exerciser can also be cleaned in this way. Keep liquids off the console. Never use abrasives or solvents. PULSE SENSOR TROUBLESHOOTING If the handgrip pulse sensor does not function properly, see step 6 on page 12. HOW TO CALIBRATE THE INCLINE SYSTEM If the elliptical exerciser's incline system is not working properly, activate the calibration process by following the steps below. 1. Hold down the Start button and the Heart Rate increase button at the same time for about five seconds. Note: Numbers may appear in the display; disregard these numbers. 2. Press the Start button again. Note: A combination of letters and numbers will appear in the display. 3. Press the 30° 1 Step Ramp button. The incline ramp will rise to the highest position and then sink to the lowest position. 4. Press the Start button three times. The console will then be in the normal operating mode and the elliptical exerciser will be ready for use. HOW TO MOVE THE ELLIPTICAL EXERCISER Stand in front of the elliptical exerciser, hold the frame firmly, and place one foot against the incline ramp in the location shown below. Pull the frame until the elliptical exerciser can be moved on the front wheels, and carefully move the elliptical exerciser to the desired location. Then, place one foot against the incline ramp, and lower the elliptical exerciser. Due to the size and weight of the elliptical exerciser, use extreme caution while moving and lowering it. Frame Place your foot here Wheel HOW TO LEVEL THE ELLIPTICAL EXERCISER If the elliptical exerciser rocks during use, turn one or both of the leveling feet under the rear stabilizer until the rocking motion is eliminated. Leveling Foot 21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28

21
Inspect and properly tighten all parts of the elliptical
exerciser regularly. Replace any worn parts immedi-
ately.
For smooth
operation of the
elliptical exer-
ciser,
inspect
and clean the
incline ramp
regularly
using
a soft cloth and
mild detergent.
Other parts of
the elliptical
exerciser can
also be cleaned
in this way.
Keep liquids off the console. Never use
abrasives or solvents.
PULSE SENSOR TROUBLESHOOTING
If the handgrip pulse sensor does not function proper-
ly, see step 6 on page 12.
HOW TO CALIBRATE THE INCLINE SYSTEM
If the elliptical exerciser’s incline system is not working
properly, activate the calibration process by following
the steps below.
1.
Hold down the Start button and the Heart Rate
increase button at the same time for about five
seconds. Note: Numbers may appear in the dis-
play; disregard these numbers.
2.
Press the Start button again. Note: A combination
of letters and numbers will appear in the display.
3.
Press the 30° 1 Step Ramp button. The incline
ramp will rise to the highest position and then sink
to the lowest position.
4.
Press the Start button three times. The console
will then be in the normal operating mode and the
elliptical exerciser will be ready for use.
HOW TO MOVE THE ELLIPTICAL EXERCISER
Stand in front of the elliptical exerciser, hold the frame
firmly, and place one foot against the incline ramp in
the location shown below. Pull the frame until the
elliptical exerciser can be moved on the front wheels,
and carefully move the elliptical exerciser to the
desired location. Then, place one foot against the
incline ramp, and lower the elliptical exerciser.
Due to
the size and weight of the elliptical exerciser, use
extreme caution while moving and lowering it.
HOW TO LEVEL THE ELLIPTICAL EXERCISER
If the elliptical
exerciser rocks
during use, turn
one or both of
the leveling feet
under the rear
stabilizer until
the rocking
motion is elimi-
nated.
MAINTENANCE AND TROUBLESHOOTING
Incline
Ramp
Leveling
Foot
Frame
Wheel
Place your
foot here