NordicTrack Cx 1055 Elliptical Exerciser English Manual - Page 7

5. See the inset drawing. While another person tips the elliptical exerciser as shown, place a sturdy piece of 5 packaging foam beneath the elliptical exerciser. Orient the Rear Stabilizer (2) so that the holes are closer to the front. While another person steadies the elliptical exerciser, attach the Rear Stabilizer to the back of the Frame (1) with four M8 x 68mm Button Screws (110) and four M8 Split Washers (101). Carefully remove the piece of packaging foam and tip the elliptical exerciser back down. 1 2 101 110 110 6. Apply a small amount of grease to the axle on each Pivot Shaft (15). Hold a Pedal Wheel (35) inside of the bracket on the end of the Right Pedal Arm (11). Next, insert a Pivot Shaft (15) through the holes in the end of the Right Pedal Arm and the Pedal Wheel as indicated. Tighten an M8 Nylon Locknut (102) with an M8 x 25mm Washer (95) onto the end of the Pivot Shaft. Attach the other Pivot Shaft (15) and the other Pedal Wheel (35) to the Left Pedal Arm (12) in the same way. 6 15 35 35 95 102 15 Grease 11 12 7. Identify the Left Pedal (14). Attach the Left Pedal to the 7 Left Pedal Arm (12) with three M8 x 23mm Flat Head Screws (88), three M8 Washers (94), and three M8 Nylon Locknuts (102). Then, press the Left Pedal Insert (121) onto the Left Pedal. Attach the Right Pedal (13) to the Right Pedal Arm (not shown), and press the Right Pedal Insert (122) into the Right Pedal, in the same way. 7 121 88 88 14 13 122 12 94 102