NordicTrack Grt470 English Manual - Page 11

17. Press two 1 3/4Ó Square Inner Caps (35) into the 17 Press Frame (8). Lubricate the 3/8Ó x 9Ó Bolt (52). Attach the Press Frame (8) to the welded tube on the Press Upright (2) with the Bolt and a 3/8Ó Nylon Locknut (50). Do not overtighten the Nylon Locknut; the Press Arm 35 must pivot easily. 18. Press a 2Ó Square Inner Cap (28) into the lower end 18 of a Press Arm (77). Press a 1Ó Inner Cap (76) into the indicated hole in the Press Arm. Attach the Press Arm (77) to the bracket on the Press Frame (8) with two 5/16Ó x 2 3/4Ó Bolts (89) and two 5/16Ó Nylon Locknuts (64). Repeat these steps to attach the second Press Arm (77, not shown). 50 8 Welded Tube Lubricate 52 2 8 89 89 64 Cable Assembly 19. Locate and open the parts bag labeled ÒCABLE ASSEMBLY AND PULLEYS.Ó For Cable identification and routing during steps 19 to 49, refer to the Cable Diagram and the Cable ID Chart on pages 24 and 25. 19 Important note: Although the following steps are not difficult to perform, correct cable routing is critical to the functioning of the weight system. Make sure that you wrap the cables around the pulleys exactly as shown in each step. Identify the Butterfly Cable (73). It is approximately 72 1/4Ó long, and it has a closed loop on each end. Attach the Butterfly Cable to the welded bracket on the Left Butterfly Arm (11) with a 3/8Ó x 1Ó Bolt (84) and two 3/8Ó Nylon Jam Nuts (63). Note: The loop on the Cable and the two Nylon Jam Nuts must be mounted underneath the welded bracket. 11 77 76 28 84 Welded Bracket 63 11 73