NordicTrack Grt470 English Manual - Page 9

11. Place two Weight Bumpers (51) over the indicated holes in the bracket on the Weight Base (5). Insert the Weight Guides (15) into the holes. See the inset drawing. Insert two Weight Inserts (94) into each Weight (21) as shown. Turn the Weights so the large pin grooves point toward the floor. Slide all of the included Weights (21) onto the Weight Guides (15). Make sure that the Weights are turned so the pin grooves are on the side shown. Press a Weight Tube Bumper (18) into the lower end of the Weight Tube (17). Slide the Top Weight assembly (16) onto the Weight Guides (15). Attach the Weight Guides (15) to the welded tube on the Weight Base (5) with a 3/8Ó x 6 1/2Ó Bolt (55) and a 3/8Ó Nylon Locknut (50). 11 15 16 17 18 Groove Pin Grooves 5 51 94 21 Large Pin Groove 21 51 12. Attach the Weight Guides (15) to the welded tube on the Weight Upright (9) with a 3/8Ó x 6 1/2Ó Bolt (55) and a 3/8Ó Nylon Locknut (50). 50 Welded Tube 55 12 50 Welded Tube 9 55 15 13. Press a 2Ó Square Inner Cap (28) into the top of the Press Front Leg (20). 13 28 Slide the Press Front Leg (20) onto the indicated 5/16Ó x 2 1/2Ó Carriage Bolts (92) in the Press Base (6). Hand tighten two 5/16Ó Nylon Locknuts (64) onto the Bolts. Do not tighten the Nylon Locknuts yet. 20 64 64 92 6 9