NordicTrack Vgr 940 Uk Manual - Page 16

THE INFORMATION MODE/DEMO MODE The console features an information mode that keeps track of the total number of hours that the elliptical crosstrainer has been used and the total number of miles that the pedals have moved. The information mode also allows you to switch the console from miles to kilometres. In addition, the information mode allows you to turn on and turn off the demo mode. To select the information mode, press RESISTANCE button 1 and the SELECT WORKOUT button at the same time. The following information will be shown: The left LED display will show the total number of hours that the elliptical crosstrainer has been used. In addition, an "E" for English miles or an "M" for metric kilometres will appear in the display. Press the START PROGRAM button to change the unit of measurement, if desired. The right LED display will show the total number of miles that the pedals have moved. IMPORTANT: Make sure that there is not a "d" in the right display. If a "d" appears in the display, the console is in the "demo" mode. This mode is intended to be used only when an elliptical crosstrainer is displayed in a store. When the console is in the demo mode, the power supply can be plugged in and the displays and indicators on the console will automatically light in a preset sequence, although the buttons on the console will not operate. If a "d" appears in the right display when the information mode is selected, press the SELECT WORKOUT button so the "d" disappears. To exit the information mode, press RESISTANCE button 1 and the SELECT WORKOUT button at the same time. MAINTENANCE AND TROUBLESHOOTING For smooth operation of the elliptical crosstrainer, the incline frame should be kept clean. Incline Frame Using a soft cloth and mild Wheel detergent, clean dust and other residue from the incline frame where the wheels make contact with it. Other parts of the elliptical crosstrainer can also be cleaned in this manner. Never use abrasive or solvents. Inspect and tighten all parts of the elliptical crosstrainer regularly. Replace any worn parts immediately. CALIBRATING THE RESISTANCE SYSTEM If the elliptical crosstrainer's resistance system is not working properly, you may need to activate the calibration process. To activate the resistance calibration process, press RESISTANCE button 1. Wait for the resistance motor to stop. Next, press RESISTANCE button 10. Whilst the resistance motor is running, unplug the power supply from the elliptical crosstrainer (see step 11 on page 8). Do not unplug the power supply from the wall. Wait for a few seconds and then plug the power supply back into the elliptical crosstrainer. The resistance system will now calibrate itself. It will not need to be calibrated again. 16