Onkyo AVX-290 Owner Manual - Page 42

Resetting REMOTE MODE Buttons You can reset a REMOTE MODE to its default remote control code. 1 While holding down REMOTE MODE that you want to reset, press and hold down AUDIO until the remote indicator lights (about 3 seconds). 2 Within 30 seconds, press REMOTE MODE again. The remote indicator flashes twice, indicating that the button has been reset. Each of REMOTE MODE is preprogrammed with a remote control code. When a button is reset, its preprogrammed code is restored. Resetting the Remote Controller You can reset the remote controller to its default settings. 1 While holding down RECEIVER, press and hold down AUDIO until the remote indicator lights (about 3 seconds). 2 Within 30 seconds, press RECEIVER again. The remote indicator flashes twice, indicating that the remote controller has been reset. Controlling Other Components By pressing REMOTE MODE that's been programmed with the remote control code for your component, you can control Onkyo component as below. For details on entering a remote control code for a different component (➔ page 41). Controlling a Blu-ray Disc/DVD Player, HD DVD Player BD/DVD is preprogrammed with the remote control code for controlling a component that supports the Q*1. The component must be able to receive remote control commands via Q and be connected to the AV receiver via HDMI. Use the following remote control codes: ` 32910/31612: Blu-ray Disc/DVD player with Q *1 The Q supported by the AV receiver is the CEC system control function of the HDMI standard. En 42