Onkyo AVX-290 Owner Manual - Page 47

■ The AV receiver unexpectedly selects your iPod/iPhone as the input source Always pause iPod/iPhone playback before selecting - a different input source. If playback is not paused, the Direct Change function may select your iPod/iPhone as the input source by mistake during the transition between tracks. Recording ■ Can't record On your recorder, make sure the correct input is - selected. To prevent signal loops and damage to the AV - receiver, input signals are not fed through to outputs with the same name (e.g., VCR/DVR IN to VCR/DVR OUT). Others ■ Standby power consumption In the following cases, the power consumption may reach up to a maximum of 31 W: 1. You are using the Universal Port jack. 2. "HDMI Ctrl (RIHD)" setting is set to "On". (Depending on the TV status, the AV receiver will enter Standby mode as usual.) 34, 38 ■ The sound changes when I connect my headphones When a pair of headphones is connected, the - listening mode is set to Stereo, unless it's already set to Stereo, Mono, or Direct. ■ How do I change the language of a multiplex source Use the "Input Ch (Mux)" setting on the "Audio 31 Adjust" menu to select "Main" or "Sub". ■ The V functions don't work To use V, you must make an V connection and 15 an analog audio connection (RCA) between the component and AV receiver, even if they are connected digitally. ■ The following settings can be made for the composite video inputs You must use the buttons on the unit to make these settings. On the AV receiver, press the input selector for the input source that you want to set and the SETUP button simultaneously. While holding down the input selector button, press SETUP until "Video ATT:ON" appears on the display. Then, release both buttons. To reactivate the setting, repeat the above process so that "Video ATT:OFF" appears on the display, and release the buttons. • Video Attenuation This setting can be made for the BD/DVD, VCR/DVR, CBL/SAT, GAME, or AUX input. If you have a games console connected to the composite video input, and the picture isn't very clear, you can attenuate the gain. Video ATT:OFF: (default). Video ATT:ON: Gain is reduced by 2 dB. ■ If the picture on your TV/monitor connected to HDMI OUT is unstable, try switching the DeepColor function off To turn off the DeepColor function, simultaneously press the CBL/SAT and  ON/STANDBY buttons on the AV receiver. While holding down CBL/SAT, press  ON/STANDBY until "Off" appears on the display. Then, release both buttons. To reactivate the DeepColor function, repeat the above process until "On" appears on the display and release the buttons. The AV receiver contains a microcomputer for signal processing and control functions. In very rare situations, severe interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely event that this happens, unplug the power cord from the wall outlet, wait at least five seconds, and then plug it back in again. Onkyo is not responsible for damages (such as CD rental fees) due to unsuccessful recordings caused by the unit's malfunction. Before you record important data, make sure that the material will be recorded correctly. Before disconnecting the power cord from the wall outlet, set the AV receiver to Standby. En 47