Onkyo HT-R693 Owners Manual - Page 6
Other connections, AM/FM antenna connections, Network connection, Headphones connection
View all Onkyo HT-R693 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Cut and remove the plastic coating from the end of the speaker cable, twist the core and connect it to the terminal. Make correct connection between the unit's jacks and speaker's jacks (+ to + and - to -) for each channel. If connection is wrong, a bass sound may become poor due to reverse phase. ¼The speaker terminals of the home theater package are colored for easy identification. Connect a color-coated wire (+) of each speaker cable to the corresponding speaker terminal of the same color. Connect a subwoofer by connecting the LINE INPUT jack to the PRE OUT SUBWOOFER jack as shown in the figure. ¼Up to two subwoofers with built-in power amplifier can be connected to this unit. Set the cut-off filter selection switch of the subwoofer to DIRECT, if applicable. If the subwoofer does not have a cut-off filter selection switch but has a cut-off frequency adjusting dial, turn it to the maximum frequency. If your subwoofer does not have built-in power amplifier, you can connect a power amplifier between the unit and the subwoofer. Note Short-circuiting the + cable and - cable or contacting the cable core to the rear panel of the unit may cause failure. Also do not connect two or more cables to one speaker terminal or one speaker to several terminals. 3 Other connections AM/FM antenna connections Connect the antennas to listen to AM/FM broadcast. When listening to the broadcast for the first time, adjust the antenna position and orientation to get the best reception. AM loop antenna (supplied) Indoor FM antenna (supplied) (North American model) Fix with a tack on the wall. (European model) Assemble the AM loop antenna (supplied). Step 1: Connections Network connection You can enjoy Internet radio and DLNA by connecting the unit to LAN. The unit can be connected to the router with an Ethernet cable or to the wireless LAN router with Wi-Fi connection. In case of wired connection, connect the Ethernet cable to the ETHERNET port. For Wi-Fi setup, see "4th Step : Network Connection" of "Step 2: Setting Up". Internet radio PC Router NAS Headphones connection %QPPGEVUVGTGQJGCFRJQPGUYKVJCUVCPFCTFRNWI |KPEJ or ø 6.3 mm) to the PHONES jack on the front panel. Sound from the speakers will be off while you are using the headphones. r If you selected any other listening mode than Pure Audio (European model), Stereo, Mono and Direct, connecting headphones will switch the listening mode to Stereo. When using commercially available banana plugs, tighten the speaker terminals to the end and then insert the banana plugs. Do not insert the core of speaker cable directly into the hole for banana plug of speaker terminal. (North American model) 6