Onkyo HT-R693 Owners Manual - Page 7
Setting Up - remote
View all Onkyo HT-R693 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Step 2: Setting Up Important: When the unit is turned on for the first time, the setup wizard of the section 2 will automatically be launched. If you use the setup wizard to make the initial setup, connect a TV to the HDMI OUT MAIN jack of the unit via HDMI connection. 1 Turning the power on Connect the power cord to the outlet. Press zON/STANDBY on the main unit or zRECEIVER on the remote controller to turn the unit on or to standby mode. Initial Setup Language Select English Deutsch Français Español Italiano Nederlands Svenska HOME Exit 2 Making the Initial Setup with the Setup Wizard Read before starting the procedure: Set up by answering the guidance displayed on the TV screen. Select the item with the cursors of the remote controller and press ENTER to confirm your selection. To return to the previous screen, press RETURN. r If you terminate the procedure on the way or change the setting made in the initial setup and want to call up the setup wizard again, press RCV and then HOME on the remote controller, select "Setup" - "7.Hardware Setup" - "Initial Setup", and press ENTER. Select the language first. In the next screen, the summary of the setup wizard as below will be displayed. Select "Yes" in this screen and press ENTER on the remote controller. Initial Setup Firmware update notification: If the unit is connected via LAN and there is firmware update available, the "Firmware Update Available" message will appear. To execute updating, select "Update Now" with the cursors of the remote controller and press ENTER. When "Completed!" appears, press zON/STANDBY on the main unit to turn the unit into standby mode. Then updating will be completed. r The unit automatically turns itself into standby mode |OKPWVGUCHVGT%QORNGVGFCRRGCTUQPVJGFKURNC[+P this case also, updating will be completed. Welcome to initial setup. Have you connected all the speakers and devices? Before starting, please connect speakers and sources. Now, would you like to start initial setup? 1st Step : AccuEQ Room Calibration 2nd Step : Source Connection 3rd Step : Remote Mode Setup 4th Step : Network Connection Yes No HOME Exit The setup wizard proceeds in the four steps as below. 1st Step : AccuEQ Room Calibration 2nd Step : Source Connection 3rd Step : Remote Mode Setup 4th Step : Network Connection 1st Step : AccuEQ Room Calibration The test tone coming from each speaker will be measured to enable setting of the number of speakers, volume level, each speaker's optimum crossover frequencies, and distance from the primary listening position. Initial Setup AccuEQ Room Calibration This step you can automatically calibrate your room to get correct surround sound. Would you like to cailbrate your room now or later? Do it Now Do it Later HOME Exit 1. Place the speaker setup microphone. When the start screen above is displayed, before starting the procedure, place the supplied speaker setup microphone at the measurement position by referring to the figure below. TV ɿListening area ɿMeasurement position with microphone ¼Correct measurement will not be possible if the microphone is held by hand. Measurement is not possible if headphones are being used. ¼The subwoofer sound may not be detected since it is extremely low frequencies. Set the subwoofer volume to around the half of its maximum volume and make its frequency to the maximum level. ¼A loud test tone will be heard during measurement. Measurement may be interrupted if there is ambient noise or radio frequency interference. Close the window and turn off the home appliance and fluorescent light. 7