Onkyo HT-S3200 B User Manual - Page 69
Recording, Others, Video Attenuation, Video ATT:0
View all Onkyo HT-S3200 B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
Troubleshooting-Continued • If the AV receiver is installed in a rack or cabinet with colored-glass doors, the remote controller may not work reliably when the doors are closed. • Make sure you've selected the correct remote controller mode (pages 13 and 63-66). • Make sure to set the same ID on both the AV receiver and remote controller (page 58). • Make sure you've entered the correct remote control code (page 61). Can't control other components • If it's an Onkyo component, make sure that the V cable and analog audio cable are connected properly. Connecting only an V cable won't work (page 34). • Make sure you've selected the correct remote controller mode (pages 13 and 63-66). • If you've connected an V-capable Onkyo MD recorder, CD recorder, or RI Dock to the TV/TAPE IN/OUT jacks, or an RI Dock to the CBL/SAT IN or VCR/DVR IN jacks, for the remote controller to work properly, you must set the Input Display to "MD", "CDR", or "DOCK", respectively (page 37). • The entered remote control code may not be correct. If more than one code is listed, try each one. • With some AV components, certain buttons may not work as expected, and some may not work at all. • To control an Onkyo component that's connected via V, point the remote controller at the AV receiver. Be sure to enter the appropriate remote control code first (page 62). Recording Can't record • On your recorder, make sure the correct input is selected. • To prevent signal loops and damage to the AV receiver, input signals are not fed through to outputs with the same name (e.g., TV/TAPE IN to TV/TAPE OUT or VCR/DVR IN to VCR/DVR OUT). Others The sound changes when I connect my headphones • When a pair of headphones is connected, the listening mode is set to Stereo, unless it's already set to Stereo, Mono or Direct in which case it stays the same. How do I change the language of a multiplex source • On the "7. Audio Adjust" menu, change the "Input (Mux)" setting to "Main" or "Sub" (page 56). The V functions don't work • To use V, you must make an V connection and an analog audio connection (RCA) between the component and AV receiver, even if they are connected digitally (page 34). The following settings can be made for the composite video inputs You must use the buttons on the unit to make these settings. 1. While holding down the input selector button for the input source that you want to set, press the [SETUP] button. 2. Use the Left and Right [F]/[S] buttons to change the setting. 3. Press the input selector button for the input source that you want to set when you've finished. • Video Attenuation This setting can be made for the DVD/BD, VCR/DVR, CBL/SAT, or AUX input. If you have a games console connected to the composite video input, and the picture isn't very clear, you can attenuate the gain. Video ATT:0: (default). Video ATT:2: Gain is reduced by 2 dB. The AV receiver contains a microcomputer for signal processing and control functions. In very rare situations, severe interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely event that this happens, unplug the power cord from the wall outlet, wait at least 5 seconds, and then plug it back in again. Onkyo is not responsible for damages (such as CD rental fees) due to unsuccessful recordings caused by this unit's malfunction. Before you record important data, make sure that the material will be recorded correctly. Before disconnecting the power cord from the wall outlet, set the AV receiver to Standby. 69