Onkyo HT-S570 Owner Manual - Page 5
Before Using the HT-R320
View all Onkyo HT-S570 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Before Using the HT-R320 Installing the Batteries 1 Open the battery compartment, as shown. 2 Insert the two supplied batteries (AA/R6) in accordance with the polarity diagram inside the battery compartment. Using the Remote Controller To use the remote controller, point it at the HT-R320's remote control sensor, as shown below. The HT-R320's STANDBY indicator flashes while a signal is being received from the remote controller. Remote control sensor HT-R320 Standby indicator 30˚ 30˚ Approx. 16 feet (5m) 3 Close the battery compartment. Notes • The supplied batteries should last for about six months, although this will vary with usage. • If the remote controller doesn't work reliably, try replacing both batteries. • Don't mix new and old batteries, or different types of batteries. • If you intend not to use the remote controller for a long time, remove the batteries to prevent possible leakage and corrosion. • Flat batteries should be removed as soon as possible to prevent possible leakage and corrosion. Notes • The remote controller may not work reliably if the HT-R320 is subjected to bright light, such as direct sunlight or inverter-type fluorescent lights. Keep this in mind when installing the HTR320. • If another remote controller of the same type is used in the same room, or the HT-R320 is installed close to equipment that uses infrared rays, the remote controller may not work reliably. • Don't put anything, such as a book, on the remote controller, because the buttons may be pressed inadvertently, thereby draining the batteries. • The remote controller may not work reliably if the HT-R320 is installed in a rack behind colored glass doors. Keep this in mind when installing the HT-R320. • The remote controller will not work if there's an obstacle between it and the HT-R320's remote control sensor. 5