Onkyo LS3100 Owner Manual - Page 21

Useful Function Programming the controller for use of existing remote controller The controller can be operated with your existing TV remote controller or any other remote controller by programming the controller. This section explains how to program the controller to operate ON/STANDBY function on the controller by pressing the 5 (number button) on your TV remote controller as an example. This operation can be done only from the top panel. Settable button operation The following button operation can be set. On/Standby Volume -/+ Mute Bluetooth Sound Mode Setting the button operation Here is an example of operating the ON/STANDBY button function of the controller by pressing the 5 (number button) on your TV remote controller. 1 Simultaneously press and hold the /TV input button and ON/STANDBY for three seconds. The mode is switched to the remote controller programming mode and ON/STANDBY LED flashes amber. 2 Aim your TV remote controller to the remote control sensor of the controller and press 5 (number button) on your TV remote controller three times within 10 seconds. The ON/STANDBY LED flashes amber twice indicating that the registration is completed. Tip • If the ON/STANDBY LED does not flash by pressing the buttons on your TV remote controller, your TV remote controller might be the type that the controller cannot read. In this case, use the supplied remote controller. ■ Button operation Operating function ON/STANDBY Volume + Volume - Mute /TV input Sound Mode Button operation on the controller + ON/STANDBY + Volume + + Volume - + Volume + + Volume - + ON/STANDBY + Volume + + ON/STANDBY + Volume - Note • Operating one button operation on the controller by several other remote controllers is not possible. • If you use the remote controller programming function, TV remote controller preprogrammed code registered in the controller cannot be used (➔ page 10). If you operate the controller with your TV remote controller by using TV remote controller preprogrammed code, the controller should be initialized (➔ page 22). En 21