Onkyo TX SR804 Instruction Manual - Page 89

R EVEL MUTING DISC TAPE CH SEL Controlling Other Components-Continued Learning Commands from Other Remote Controllers The AV receiver's remote controller can receive and learn commands from other remote controllers. By transmitting, for example, the Play command from your CD player's remote controller, the remote controller can learn it and then transmit the exact same command when its Play [ ] button is pressed in the CD remote mode. You can also use this function to learn individual commands after entering a remote control code (page 86). 1 1, 4 ON STANDBY I T V INPUT V1 V2 V3 1 2 3 + V4 MULTI CH DVD T V CH 4 5 6 - CD TAPE TUNER 7 8 9 PHONO T V VOL +10 0 CLEAR --/ --- 10 11 12 INPUT SELECTOR MACRO 1 2 3 ZONE2 RECEIVER TAPE/AMP REMOTE MODE DVD CD HDD TV DIMMER + CH DISC ALBUM - VCR CABLE CDR TOP MENU MENU ENTER SAT MD SLEEP VOL PREV CH DISPLAY RETURN SET UP MUTING Remote indicator 1 REMOTE MODE RECEIVER TAPE/AMP DVD CD HDD TV VCR CABLE SAT CDR MD While holding down the REMOTE MODE button for the mode in which you want to use the command, press the [ON] button. The Remote indicator lights up. ON 2 On this AV receiver's remote con- troller, press the button you want to learn the new command. 3 Point the remote controllers at each other, about 2 to 6 inches (5-15 cm) apart, and then press and hold the button whose com- mand you want to learn until the Remote indicator flashes. If the command is learned successfully, the Remote indicator flashes twice. TOTNEEST VOLUME VIDEO-2 DVGTDRAOPUEPINPTUUTTNSUEPENRLREEERCSPTEDITHOMORNMEOR MOSDUER CD INMPULUTTI-CH VIDEO-1 CD SLEEP About 2 to 6 inches (5-15 cm) DVD POWER ON MENU PE/AREMCEPIVER VCR 1 DVD REM-O-T/I-C2NEM-D-PM+AU1CO1T00RDPSOEHEOLNEO3CT70O11R CD 1 V1 4 V4 8 TAPE 5 MULTI 2 CH 9 TUNER 6 CLEAR 12 TV VOL V2 DVD STANDBY I 3 V3 - TV CH + CDRCABLE HDD ZONE2 MDSAT SLEEP T V INPUT RC-620M 4 To learn more commands, repeat steps 2 and 3. Press any REMOTE MODE button when you've finished. Notes: • The following buttons cannot learn new commands: REMOTE MODE, MACRO [1], [2], [3], TV [ ], TV [INPUT], TV CH [+]/[-], TV VOL [ ]/[ ], Light. • The remote controller can learn approximately 70-90 commands, although, this will be reduced by commands that use a lot of memory. • Remote controller buttons such as Play, Stop, Pause, and so on are preprogrammed with commands for controlling Onkyo CD players, cassette decks, and DVD players. However, they can learn new commands, and you can restore the preprogrammed commands by resetting the remote controller (see page 87). • To overwrite a previously learned command, repeat this procedure. • Only commands from infrared remote controllers can be learned. • When the remote controller's batteries expire, all learned commands will be lost and will have to be learned all over again, so don't discard your other remote controllers. 89