Oreck XL 2600HH Owners Guide - Page 4
Operating Instructions Assembly - vacuum
View all Oreck XL 2600HH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
ENGLISH Assembly Operating Instructions To assist you in identifying components of your vacuum, the parts have been numbered as follows: 1 Handle section, upper 2 Tube, lower 3 Power head 4 Outer bag 5 Paper filter dust bag 6 Power cord 5 7 Retaining spring 8 Bag tension bar 9 Zip fastener 10 On/off switch 11 Cord hook 12 Plastic loop/cable clamp 13 Connector assembly 14 Fan housing 15 Cord assembly 10 91 11 12 13 4 2 6 87 14 15 3 1 Before assembling appliance, remove two screws from the connector assembly. Remove cardboard insert by pulling upward. 2 Upper Handle With ON/OFF switch facing the front of the unit, slide upper handle section over matching section of the Connector Assembly connector assembly. Insert short screw into top hole and long screw into the bottom hole then tighten firmly until handle is no longer loose. 3 Attach cord to cord clip by pressing cord above and below clip ensuring the cord is fully rested in clip. To Operate Make sure disposable paper filter dust bag is in place. DO NOT operate the cleaner without a paper filter dust bag. Plug the power cord into an electrical outlet and press the On(l) - OFF(O) switch on handle assembly when ready to operate. General Information The performance of your new cleaner greatly depends upon care and maintenance. The instructions in this manual will guide you in performing basic care and maintenance. To obtain the most satisfying years of service read the instructions and keep them handy for future reference. Operating Recommendations This new ORECK XL High-Speed Upright is one of the finest, fastest, and strongest units in its class. You'll love the way it cleans, gets under things, and it's SO lightweight and easy to use. The following are a few simple suggestions regarding its operation: 1. When inserting a new disposable paper filter dust bag- FIRST PUFF OUT and OPEN THE BAG. 2. When the disposable filter dust bag is full, REPLACE IT. 3. If at any time the machine does not pick up properly or makes an unusual noise, STOP OPERATION and service. 4. Although your upright will pick up pins, paper clips, and other small objects, it is recommended that these be removed from the floor before you vacuum. Failure to do so may result in permanent damage to the motor suction fan and its housing. 5. WARNING: Do not use your vacuum cleaner on damp or wet surfaces. This will cause damage to the vacuum cleaner and is dangerous to the user. Damage caused by use on wet or damp surfaces is not covered under warranty. 6. REPLACE THE BELT EVERY 6 MONTHS. 7. Change the disposable filter dust bag at least once a month-even if it is not full! The collected dust in the dust bag can cause odor, attract moisture, act as a breeding area and can affect the efficiency of the cleaner. 8. DO NOT run the vacuum cleaner over cord. The revolving brush could damage the cord. Disposable Paper Filter Dust Bags Disposable paper filter dust bags play a very important role in the efficiency of your ORECK vacuum cleaner. The purpose of the paper bag is to trap dirt, but at the same time it must be porous enough to allow air to pass through. If the paper bag becomes clogged, no air can pass through the cleaner and cleaning cannot take place, regardless of the cleaner's power. Increase the CLEANING POWER of your cleaner by changing the bag often. To keep your cleaner operating at maximum efficiency, change the dust bag frequently. DO NOT FILL ABOVE THE LINE INDICATED ON THE DUST BAG. Be sure the disposable paper filter dust bag is installed properly. 4