Oreck XL 2600HH Owners Guide - Page 5

ENGLISH All paper dust bags are not the same. Your ORECK disposable dust bags have been designed to be used with the ORECK cleaner. Using bags other than genuine ORECK disposable bags will affect the cleaning ability of your cleaner and could cause damage to it. The Belt The belt on your vacuum cleaner controls the speed of the revolving brush and is very important for the effective operation of the cleaner. If the belt becomes stretched or cut, it will cause the revolving brush to stop completely or slow down. See instructions in the manual for replacing belt. An extra belt is stored in the baseplate of your cleaner. When buying replacement belts, use ONLY ORECK genuine belts. Belts other than ORECK belts will not operate the revolving brush correctly and may create undue stress which will cause damage to the motor and brush bearings. Using belts other than ORECK belts will void the warranty. Lubrication The vacuum cleaner motor bearings are factory lubricated and seated. Further lubrication is not required. General Cleaner Care At least once a month, check for and remove excessive lint, string or hair from revolving brush. Wipe the outside of the cleaner with a damp cloth. Also clean the connector deflector assembly area, base of cleaner and fan housing area. If there is dust in the outer bag, vacuum it or shake it out. A little preventative maintenance will keep your cleaner looking new and will ensure continued cleaning effectiveness. CAUTION-Wood Floors Use floor and floor finish manufacturer's recommended methods of cleaning. The metal strip on the base of the cleaner could be damaged if used on concrete or abrasive surfaces, and, therefore, cause damage to wood floors. The roller brush may also scuff very soft finishes. Do not operate the unit while in the upright and locked position. Do not let the unit run while in any one stationary position for any period of time. Keep the unit moving while in operation. XL2600HH & XL2700HH: Celoc® Hypo-Allergenic Filter System The CELOC SMMS outer bag of your vacuum cleaner is high filtration medical material designed to filter the smallest of dust particles. It is important the inside of the outer bag be cleaned. Vacuum the inside of the outer bag or hand wash, turned inside out, with warm water, and air dry. For best results, the CELOC SMMS outer bag should be replaced once a year. The CELOC layered disposable inner dust bag must be replaced once a month even if it is not full. Change it more often if it is used in extremely dirty areas. Increase the cleaning power of your vacuum by changing the bag often. 5 To Replace Filter Dust Bag WARNING: Unplug cord from electrical outlet before servicing. BAG REMOVAL: 1. Pull bag cardboard collar to release bag dock door from connector. Bag dock door will hinge downward. 2. Gently pull bag card cardboard collar upward out of the bag dock. Dust seal will close automatically BAG INSTALLATION: 1. Slide the cardboard collar completely onto bag dock door. ENFONCEZ JUSQU'À ENTENDRE UN BRUIT PRESIONE HASTA ESCUCHAR UN CHASQUIDO DE SUJECIÓN 2. Firmly push bag dock door with both thumbs on indication point until it snaps.