Panasonic AG-DVX100BPS Operating Instructions - Page 46

Setting menus OTHER FUNCTIONS screen Item/ (display mode) Description of settings REMOTE (Camera) (VCR) DV CONTROL (Camera) DV CMD SEL (Camera) REC LAMP (Camera) For setting the operations which are performed using the accessory wireless remote control unit. (See page 20 for the remote control unit settings.) VCR1: The operation performed by the remote control unit which has been set to be used for VCR1 are accepted. VCR2: The operation performed by the remote control unit which has been set to be used for VCR2 are accepted. OFF: Operations performed by the remote control unit are not accepted. For setting the control method when backup shooting is to be performed by connecting a component for backup purposes to the DV connector. OFF: The component for backup purposes is not controlled. EXT: The component for backup purposes is controlled using the START/STOP button on the camera recorder. The images shot by the camera recorder are recorded by the component for backup purposes. However, the camera recorder does not record the images. BOTH: The images shot by the camera recorder are recorded by both camera recorder and the component for backup purposes. CHAIN: When the tape in the camera recorder approaches the end during shooting, recording is automatically commenced by the component for backup purposes, which has been set to the recording standby mode. For setting the recording operation to be performed by the component for backup purposes when the START/STOP button on the camera recorder has been pressed. REC_P: The mode is switched between recording and recording pause. STOP: The mode is switched between recording and stop. Select STOP as the item's setting if the component for backup purposes is not equipped with a recording pause function. For setting the lighting of the tally lamps. OFF: The tally lamps do not light. FRONT: The front tally lamp (by the microphone) lights. REAR: The rear tally lamp (by the viewfinder) lights. BOTH: Both the front and rear tally lamps light. The underlining indicates the factory setting. 46 Item/ (display mode) Description of settings BEEP SOUND (Camera) For setting the beep tone to ON or OFF. OFF ON When ON is selected as the setting, the beep tone is sounded at the times given below. O When the beep tone is sounded, the audio signals from the output connectors are muted, and the beep tone is output instead. [Beep tone sounds once] OWhen the POWER switch has been set to ON OWhen shooting has commenced [Beep tone sounds twice] OWhen shooting has been temporarily stopped [Beep tone sounds 10 times] OWhen the cassette tape has not been inserted OWhen the cassette tape is in the recording pause mode OWhen condensation has formed inside the camera recorder OWhen a problem has occurred in the camera recorder CLOCK SET (Camera) (VCR) For setting the internal calendar of the camera recorder. TIME SHIFT (Camera) (VCR) For adding the time which was set using this item to the time of the internal calendar (to compensate for time differences) for display in the viewfinder and on the LCD monitor. The clock time after the compensation is also recorded on the tape. +23h --- +1h, OFF, -1h --- -23h (In 1-hour increments) TAPE PROTECT (Camera) When the camera recorder is left on standby for about 5 minutes in the shooting pause mode, it is automatically set to the tape protection mode. Which tape protection mode is to be established is selected using this item. POWEROFF: The camera recorder's power is set to the OFF mode. STBY: The cylinder head is set to the stop mode. USER FILE (Camera) (VCR) LOAD: The settings stored last in the user file are loaded. SAVE: The user file settings which have been changed are saved. INITIAL: The user file settings are restored to the factory settings. O When the LOAD or INITIAL operation has been performed, set the POWER switch on the camera recorder to OFF and then to ON again in order to enable the settings. HOUR METER (Camera) (VCR) For indicating the total rotational time of the cylinder head (5-digit display in 1-hour increments).