Panasonic CF-74ECBAXBM Service Manual - Page 37
Setting the SD PCB, Heat Sink and FAN Motor
UPC - 092281864044
View all Panasonic CF-74ECBAXBM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
10.2.6. Setting the SD PCB, Heat Sink and FAN Motor 1. Connect the SD FFC to the Connector (CN1401). 2. Fix the SD PCB to the computer using the three Screws. 3. Set the Heat Sink, Fan Duct and the four Heat Sink Springs. 4. Fix the FAN Motor to the computer using the two Screws. 5. Attach the Fan Tape 1 and 2 on the FAN Motor, and fix the Cable Holder on them. Screws : DXSB2+6FNL Screws : DFHE5025XA Cable Holder Fan Tape1 Fan Duct SD PCB SD FFC CN1401 Heat Sink Spring Fan Tape2 FAN Motor Heat Sink Heat Sink Spring n Applying Grease on the Heat Sink 1. Apply grease on two points of the Heat Sink. 2. Attach the Pipe Sheet on the Heat Pipe. Fan Dust Sheet (Attach the Fan Duct Sheet to the back side.) Match the end of the Pipe Sheet. 0~1mm (0 ~ -2mm) 0~1mm Pipe Sheet Fold on the center line and attach it. 0~1mm 5~10mm 0~1mm Fan Dust Sheet Heat Sink Grease is applied. G751(10mmX10mmXt0.3) Grease is applied. G751(10mmX10mmXt0.3) 10-13