Panasonic CF29LTQGZBM CF29L3LGZBM User Guide - Page 38
Backing Up and Restoring Data
View all Panasonic CF29LTQGZBM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Hard Disk Backup Function Select [2], enter the partition size (GB), and press Enter . • You can cancel this operation by pressing 0 . • The data partition size will be the maximum settable size less the number entered above. The maximum settable size will differ depending on models. [At the time of purchase] The usable hard disk area [After the backup area is created] The backup area Can be accessed from Windows (Two partitions). Cannot be accessed from Windows. 9 At the confirmation message, press Y . The backup area is then created. 10 When the message [You must reboot in order to enable the Backup function] appears, remove the recovery CD, and press any key to restart the computer. The computer is restarted, then the backup process will begin. 11 When the message [[Backup] is complete] appears, press Ctrl + Alt + Del to restart the computer. CAUTION Do not press Ctrl + Alt + Del until the message is displayed. 12 After logging on to Windows, a message will appear advising that a new device has been installed and that the computer must be restarted to enable the settings. Select [Yes] to restart the computer. NOTE The [Boot] menu in the Setup Utility is set to start up from the CD/DVD drive. Change this setting if necessary. The next time the backup or restore functions are executed, follow the procedure for "Backing Up and Restoring Data" ( below). Backing Up and Restoring Data CAUTION Before executing the backup function, execute a disk error check ( page 36). Do not interrupt the backup or restore functions before completion, for example by turning off the power or pressing Ctrl + Alt + Del , as this may prevent Windows from starting up, or may cause data to be lost so that the backup and restore functions cannot be executed. 1 Turn the computer on, and press F2 while [Panasonic] boot screen is displayed. The Setup Utility will start up. If a password has been set, enter the Supervisor Password or the User Password. 2 Select [Exit] menu, then select [Hard Disk Backup / Restore] and press çEnter . At the confirmation message, select [Yes] and press çEnter . Appendix 38