Panasonic DMR-EZ28K Dvd Recorder - English / Spanish - Page 68
Error Messages, On the Unit's Display - remote
UPC - 037988256624
View all Panasonic DMR-EZ28K manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
Error Messages On the Unit's Display H ,F (" " stands for a service number.) RC (" " stands for a number.) HARD ERR ("HArd" and "Err" are alternately displayed.) NO READ ("NO" and "REAd" are alternately displayed.) FULL UNSUPPORT ("UNSUP" and "POrt" are alternately displayed.) UNFORMAT ("UNFOr" and "MAt" are alternately displayed.) " " is displayed on the unit's display. F74 F75 U59 U61 U72 U73 U76 U88 U99 68 • An error has occurred. The number following "H" or "F" depends on the status of the unit. Check the items below and in the Troubleshooting Guide. If the service number still does not disappear after the check, reset the unit (➔ 70, "To restore the unit if it freezes" ). • If the service numbers fail to clear, note the service numbers and contact a qualified service person. • The remote control and the main unit are using different codes. Change the code on the remote control. • If there is no change after turning the unit on and off, consult the dealer where the unit was purchased. Page − − 48 − • The disc is dirty or badly scratched. The unit cannot record, play, or edit. • The disc may be incompatible or of poor quality. • You have used a lens cleaner and it has finished operation. Press [; OPEN/CLOSE] on the main unit to eject the disc. • Displayed when the unit is started. This is not a malfunction. • The unit is carrying out its recovery process. You cannot operate the unit while " " is displayed. • There are already 16 scheduled recording programs. Delete unnecessary scheduled recording programs. • You have inserted a disc the unit cannot play or record on. • You tried to operate with a non-compatible USB memory. 63 62, 63, 65 3 − − 23 62, 63 64 • You have inserted a new DVD-RW/+RW or a DVD-RAM/DVD-RW (DVD-Video format) recorded on other equipment. You can format the disc when the format confirmation screen is displayed. • This unit is confirming that it is connected with equipment compatible with HDAVI Control. 21, 44 − • The HDMI connection could not be authenticated due to a transfer − malfunction. Consult the dealer where the unit was purchased. • The HDMI connection could not be authenticated due to an internal − data malfunction. Consult the dealer where the unit was purchased. • The unit is very warm. − The unit switches to standby for safety reasons. Wait for about 30 minutes until the message disappears. Reinstall the unit in an area with adequate ventilation. Do not block the cooling fan on the rear of the unit. • There was a power failure or the AC power supply cord was disconnected while the − unit was on. The unit is carrying out its recovery process. This process restores the unit to normal operation. The unit is not broken. Wait until the message disappears. • The HDMI connection acts unusually. − - The connected equipment is not HDMI compatible. - Please use HIGH SPEED HDMI cables that have the HDMI logo (as shown on the cover). - The HDMI cable is damaged. • HDMI cannot be output because you are connected to a model that − does not support copyright protection. • There was something unusual detected with the disc while recording 71 or playing; there was a power failure or the AC power supply cord was disconnected while the unit was on. The unit is carrying out its recovery process. This process restores the unit to normal operation. The unit is not broken. Wait until the message disappears. • The unit fails to operate properly. Press [POWER ^/I] on the main unit to switch − the unit to standby. Press [POWER ^/I] on the main unit again to turn the unit on. RQT9046