Panasonic KX-TG133CSK Operating Instructions - Page 50

Error messages, Troubleshooting, to Caller ID.

Get Panasonic KX-TG133CSK PDF manuals and user guides View all Panasonic KX-TG133CSK manuals
Add to My Manuals
Save this manual to your list of manuals

Page 50 highlights

Useful Information Error messages Display message Ask phone company for VM access # Base no power or No link. Reconnect base AC adaptor. Busy Check tel line Error!! Invalid Requires subscription to Caller ID. Use rechargeable battery. Cause/solution R You have not stored the voicemail access number. Store the number (page 47). R Confirm the base unit's AC adaptor is connected to the unit and the power outlet correctly. R The handset has lost communication with the base unit. Move closer to the base unit and try again. R Unplug the base unit's AC adaptor to reset the unit. Reconnect the adaptor and try again. R The handset's registration may have been cancelled. Re-register the handset (page 36). R The called unit is in use. R Other units are in use and the system is busy. Try again later. R The handset you are using is too far from the base unit. Move closer and try again. R The supplied telephone line cord has not been connected yet or not connected properly. Check the connections (page 8). R Recording was too short. Try again. R There is no handset registered to the base unit matching the handset number you entered. R The handset is not registered to the base unit. Register the handset (page 36). R You must subscribe to a Call Display service. Once you receive caller information after subscribing to a Call Display service, this message will not be displayed. R A wrong type of battery such as alkaline or manganese was inserted. Use only the rechargeable Ni-MH batteries noted on page 4, 5. Troubleshooting If you still have difficulties after following the instructions in this section, disconnect the base unit's AC adaptor, then reconnect the base unit's AC adaptor. Remove the batteries from the handset, and then insert them into the handset again. If the base unit batteries for power backup are installed, remove the batteries from the base unit, and then insert them into the base unit again. General use Problem The handset does not turn on even after installing charged batteries. Cause/solution R Place the handset on the charger to turn on the handset. 50 For assistance, visit www.panasonic.ca/english/support TGF3xxC(en)_1216_ver011.pdf 50 2014/12/16 19:11:03

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
Error messages
Display message
Cause/solution
Ask phone
company for
VM access #
R
You have not stored the voicemail access number. Store the
number (page 47).
Base no power
or
No link. Re-
connect base
AC adaptor.
R
Confirm the base unit’s AC adaptor is connected to the unit and
the power outlet correctly.
R
The handset has lost communication with the base unit. Move
closer to the base unit and try again.
R
Unplug the base unit’s AC adaptor to reset the unit. Reconnect
the adaptor and try again.
R
The handset’s registration may have been cancelled. Re-register
the handset (page 36).
Busy
R
The called unit is in use.
R
Other units are in use and the system is busy. Try again later.
R
The handset you are using is too far from the base unit. Move
closer and try again.
Check tel line
R
The supplied telephone line cord has not been connected yet or
not connected properly. Check the connections (page 8).
Error!!
R
Recording was too short. Try again.
Invalid
R
There is no handset registered to the base unit matching the
handset number you entered.
R
The handset is not registered to the base unit. Register the
handset (page 36).
Requires
subscription
to Caller ID.
R
You must subscribe to a Call Display service. Once you receive
caller information after subscribing to a Call Display service, this
message will not be displayed.
Use rechargeable
battery.
R
A wrong type of battery such as alkaline or manganese was
inserted. Use only the rechargeable Ni-MH batteries noted on
page 4, 5.
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the base unit’s AC
adaptor, then reconnect the base unit’s AC adaptor. Remove the batteries from the handset, and then
insert them into the handset again.
If the base unit batteries for power backup are installed, remove the batteries from the base unit, and
then insert them into the base unit again.
General use
Problem
Cause/solution
The handset does not turn on
even after installing charged
batteries.
R
Place the handset on the charger to turn on the handset.
50
For assistance, visit www.panasonic.ca/english/support
Useful Information
TGF3xxC(en)_1216_ver011.pdf
50
2014/12/16
19:11:03