Panasonic KX-TG133CSK Operating Instructions - Page 51

Problem, Cause/solution, Menu list, Battery recharge, Making/answering calls, intercom, For assistance

Get Panasonic KX-TG133CSK PDF manuals and user guides View all Panasonic KX-TG133CSK manuals
Add to My Manuals
Save this manual to your list of manuals

Page 51 highlights

Useful Information Problem The unit does not work. I cannot hear a dial tone. The base unit beeps. The unit does not work during a power failure. Cause/solution R Make sure the batteries are installed correctly (page 8). R Fully charge the batteries (page 9). R Check the connections (page 8). R Unplug the base unit's AC adaptor to reset the unit. Reconnect the adaptor and try again. R The handset has not been registered to the base unit. Register the handset (page 36). R The base unit's AC adaptor or telephone line cord is not connected. Check the connections. R Disconnect the base unit from the telephone line and connect the line to a known working telephone. If the working telephone operates properly, contact our service personnel to have the unit repaired. If the working telephone does not operate properly, contact your phone service provider. R New messages have been recorded. Listen to the new messages (page 41). R You can insert 2 AAA (R03) batteries (not supplied) into the base unit that will power the unit temporarily in the event of a power failure (page 9). R The base unit display is blank if the saving mode is "On" (page 10). Menu list Problem The display is in a language I cannot read. I cannot register a handset to a base unit. Cause/solution R Change the display language (page 12). R The maximum number of handsets (6) is already registered to the base unit. Cancel unused handset registrations from the base unit (page 36). Battery recharge Problem The handset beeps and/or flashes. I fully charged the batteries, but - still flashes, - is displayed, or - the operating time seems to be shorter. Cause/solution R Battery charge is low. Fully charge the batteries (page 9). R Clean the battery ends ( , ) and the charge contacts with a dry cloth and charge again. R It is time to replace the batteries (page 8). Making/answering calls, intercom Problem is displayed. Cause/solution R The handset is too far from the base unit. Move closer. R The base unit's AC adaptor is not properly connected. Reconnect AC adaptor to the base unit. R The handset is not registered to the base unit. Register it (page 36). For assistance, visit www.panasonic.ca/english/support 51 TGF3xxC(en)_1216_ver011.pdf 51 2014/12/16 19:11:03

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
Problem
Cause/solution
The unit does not work.
R
Make sure the batteries are installed correctly (page 8).
R
Fully charge the batteries (page 9).
R
Check the connections (page 8).
R
Unplug the base unit’s AC adaptor to reset the unit. Reconnect
the adaptor and try again.
R
The handset has not been registered to the base unit. Register
the handset (page 36).
I cannot hear a dial tone.
R
The base unit’s AC adaptor or telephone line cord is not
connected. Check the connections.
R
Disconnect the base unit from the telephone line and connect
the line to a known working telephone. If the working telephone
operates properly, contact our service personnel to have the
unit repaired. If the working telephone does not operate
properly, contact your phone service provider.
The base unit beeps.
R
New messages have been recorded. Listen to the new
messages (page 41).
The unit does not work during a
power failure.
R
You can insert 2 AAA (R03) batteries (not supplied) into the
base unit that will power the unit temporarily in the event of a
power failure (page 9).
R
The base unit display is blank if the saving mode is
“
On
”
(page 10).
Menu list
Problem
Cause/solution
The display is in a language I
cannot read.
R
Change the display language (page 12).
I cannot register a handset to a
base unit.
R
The maximum number of handsets (6) is already registered to
the base unit. Cancel unused handset registrations from the
base unit (page 36).
Battery recharge
Problem
Cause/solution
The handset beeps and/or
flashes.
R
Battery charge is low. Fully charge the batteries (page 9).
I fully charged the batteries, but
–
still flashes,
–
is displayed, or
–
the operating time seems to be
shorter.
R
Clean the battery ends (
,
) and the charge contacts with a
dry cloth and charge again.
R
It is time to replace the batteries (page 8).
Making/answering calls, intercom
Problem
Cause/solution
is displayed.
R
The handset is too far from the base unit. Move closer.
R
The base unit’s AC adaptor is not properly connected.
Reconnect AC adaptor to the base unit.
R
The handset is not registered to the base unit. Register it
(page 36).
For assistance, visit www.panasonic.ca/english/support
51
Useful Information
TGF3xxC(en)_1216_ver011.pdf
51
2014/12/16
19:11:03