Panasonic PT-D3500 Dlp Projector - English/ French - Page 45
LAMP UNIT REPLACEMENT STEPS, take hold of the handles, and remove
View all Panasonic PT-D3500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Lamp unit replacement steps Attention • After 1 500 hours (4 000 hours when long life lamp units are used) of operating the same lamp, it is only possible to operate the unit for approximately 10 minutes. Steps to must be completed within 10 minutes. Turn the power off by following the steps on page 23, remove the power plug and confirm that the surroundings of the lamp unit have cooled off. Check that the fan has stopped running. Have a Phillips screwdriver ready ahead of time. Loosen one screw securing the lamp unit cover, and then open the lamp unit cover. Lamp unit cover Note • You can temporarily secure the lamp unit cover in the opened condition. By sliding the cover in the direction of the arrow, you can temporarily secure the cover or release the temporarilysecured cover. Temporarily securing the cover Lamp unit Handle Lamp unit Fixing screws Caution The lamp unit will be hot after it has been used. You might get burned if you touch it while it is still hot. Releasing the temporarily-secured cover Loosen two lamp unit fixing screws, take hold of the handles, and remove the lamp unit. Install the new lamp unit. Insert the lamp unit by pressing it applying equal force on both left and right sides. Use a Phillips screwdriver to securely tighten the two lamp unit fixing screws. Close the lamp unit cover by pushing the upper-right corner until it clicks. Firmly tighten the one screw securing the lamp unit cover. Attention • Firmly install the lamp unit and lamp unit cover. If not installed firmly, a protection circuit will function and the power will not be turned on. 45