Panasonic PT-D3500 Dlp Projector - English/ French - Page 6

Precautions with regard to safety Do not disassemble the lamp unit. • If the lamp section breaks, it may cause injury. Do not place liquid containers on top of the projector. • If water spills onto the projector or gets inside it, fire or electric shocks could result. • If any water gets inside the projector, contact an Authorized Service Center. Do not insert any foreign objects into the projector. • Do not insert any metal objects or flammable objects into the projector or drop them onto the projector, as doing so can result in fire or electric shocks. After removing the battery from remote control unit, keep it away from the reach of children. • The battery can cause death by suffocation if swallowed. • If the battery is swallowed, seek medical advice immediately. Do not allow the + and - terminals of the battery to come into contact with metallic objects such as necklaces or hairpins. • Failure to observe this may cause the battery to leak, overheat, explode or catch fire. • Store the battery in a plastic bag and keep it away from metallic objects. Replacement of the lamp unit should only be carried out by a qualified technician. • The lamp unit has high internal pressure. If improperly handled, explosion might result. • The lamp unit can easily become damaged if struck against hard objects or dropped, and injury or malfunctions may result. When replacing the lamp, allow it to cool for at least one hour before handling it. Do not bring your hands or other objects close to the air outlet port. • Heated air comes out of the air outlet port. Do not bring your hands or face, or objects which cannot withstand heat. Do not suspend the projector using only the hole used for the anti-theft clasp. • The projector may fall or sustain damage, and possibly result in injury. Caution Do not set up the projector in humid or dusty places or in places where the projector may come into contact with smoke or steam. • Using the projector under such conditions may result in fire or electric shocks. When disconnecting the power cord, hold the plug, not the cord. • If the power cord itself is pulled, the cord will become damaged, and fire, short-circuits or serious electric shocks may result. Always disconnect all cables before moving the projector. • Moving the projector with cables still attached can damage the cables, which could cause fire or electric shocks to occur. Do not place objects or other projectors on top of this unit. • The objects or projectors may lose their balance or fall off, causing possible injury. Further, stacking one projector directly on top of another may cause the projectors to become deformed, resulting in possible malfunctioning. Do not short-circuit, heat or disassemble the battery or place it into water or fire. • Failure to observe this may cause the battery to overheat, leak, explode or catch fire, and burns or other injury may result. 6