Panasonic PT60DL54J PT50DL54 User Guide - Page 9

ENGLISH POWER ON/OFF Connecting the Plug to the Wall Outlet The projection TV must first be plugged into an AC outlet. The projection TV will then be in standby mode. Turning the Power ON and OFF Always be sure to follow the procedure below to turn the Projection Television power ON and OFF. The lamp cooling fan will continue to operate for approximately one minute after the power is turned off by the remote control. After the cooling fan has stopped, the power indicator will not illuminate (Stand-by mode). If you wish to turn the power ON while the cooling fan is operating, press the power button. The power indicator on the Projection Television will then flash in green, and the projection Projection Television will turn ON as soon as the cooling fan stops. Always use the remote control or power button on the Projection Television to turn the power OFF. Caution: Do not turn off by external power strip or by pulling plug. Do not open any circuit breakers while the cooling fan is still operating. Procedure for turning ON • Press the Power button to turn the projection TV on, from Stand-by mode. Note: The Power Indicator will blink green for approximately 10 seconds, and then become green. Procedure for turning OFF • Press the Power button to turn the projection TV to Stand-by mode. Notes: • The Power Indicator will become orange for approximately 10 seconds. • The Power Indicator will blink orange for approximately 60 seconds. • The Power Indicator light will go out. Note: The Projection Television will consume a small amount of power as long as the power cord is connected to a power outlet. Power Indicator Chart LED Not illuminated Green Green blink Orange Orange blink ACTION Stand-by Power - ON Power - ON (approximately 10 seconds after) Power - OFF (Blinking mode) (approximately 10 seconds after) Power - OFF (Cooling mode) (approximately 40 seconds after) POWER ON/OFF Initial Set Up Menu For your convenience, the Initial Set Up menu will be displayed on screen when the set is turned on for the first time. If needed, follow the menus and procedures for setting up the features. IDIOMA/LANGUE To change menu language to ENGLISH, SPANISH or FRENCH. Procedure • Press VOL X to select English, Spanish or French. FIRST PLEASE CONNECT THE ANTENNA INITIAL SET UP IDIOMA/LANGUE MODE AUTO PROGRAM ENGLISH CABLE PRESS MENU TO EXIT MODE To select TV (antenna) or CABLE mode depending on the signal source. Procedure • Press VOL X to select TV or CABLE. FIRST PLEASE CONNECT THE ANTENNA INITIAL SET UP IDIOMA/LANGUE MODE AUTO PROGRAM ENGLISH CABLE PRESS MENU TO EXIT AUTO PROGRAM To automatically program all channels received through the RF input. Procedure • Press VOL X to start Auto Programming. FIRST PLEASE CONNECT THE ANTENNA INITIAL SET UP IDIOMA/LANGUE MODE AUTO PROGRAM ENGLISH CABLE PRESS MENU TO EXIT 7z