Panasonic PTDW8300U PTDS8500U User Guide - Page 120
REMOTE 2 IN terminal, Pin assignments and control
UPC - 885170011014
View all Panasonic PTDW8300U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 120 highlights
Technical Information REMOTE 2 IN terminal Using the [REMOTE 2 IN] terminal provided on the connection terminals of the main unit, it is possible to operate the projector from a control panel etc. furnished in a distant location where infrared remote control signal cannot be received. Remote control External control Remote control/External control Standby ON LAMP RGB1 VIDEO RGB2 S-VIDEO Projector set up in a meeting room DVI-D Control panel located in a different room JJPin assignments and control D-Sub 9-pin (Outside view) Pin No. Signal name GND POWER RGB1 RGB2 VIDEO S-VIDEO DVI SHUTTER RST/SET Open (H) - OFF Other Other Other Other Other OFF Controlled by remote control Short (L) GND ON RGB1 RGB2 VIDEO S-VIDEO DVI ON Controlled by external contact Attention zzBe sure to short-circuit Pins and when controlling. zzWhen pin and pin are short-circuited, the following buttons on the projector's control panel and on the remote control cannot be used. button, button In addition, the RS-232C commands and network functions that correspond to these functions cannot be used either. zzWhen pin and pin are short-circuited and then any one of pins to is short-circuited to pin , the following buttons on the projector's control panel and on the remote control cannot be used. button, buttons (RGB1, RGB2, DVI-D, SDI, VIDEO, S-VIDEO), button In addition, the RS-232C commands and network functions that correspond to these functions cannot be used either. zzThe above is explanation in the case where "REMOTE2 MODE" of "PROJECTOR SETUP" (Æpage 84) is set to "STANDARD". Appendix 120 - ENGLISH