Panasonic PTDW8300U PTDS8500U User Guide - Page 83
STATUS, When the D7700 Series is selected, DVI-D] or [SDI]., change command to be assigned
UPC - 885170011014
View all Panasonic PTDW8300U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
PROJECTOR SETUP menu QQWhen the D7700 Series is selected 111 Press ▲▼ to select input signal [DVI-D] or [SDI]. zz[RGB1], [RGB2], [VIDEO], [S-VIDEO] and [HDMI] cannot be selected. Since [RGB1], [RGB2], [VIDEO], and [S-VIDEO] are already installed on the projector, another input signal change command cannot be assigned. zz[SDI] is not shown for PT-DW8300U. 222 Press ◄► to select the input signal change command to be assigned to the selected input signal. zzThe signal change command can be selected to either [AUX] or [NONE]. zzThe same input signal change command cannot be assigned to both [DVI-D] and [SDI]. STATUS Displays the status of the projector. 1111 Press ▲▼ to select [STATUS]. 2222 Press button. 3333 Press ◄► to move to the next page. INPUT SIGNAL NAME SIGNAL FREQUENCY PROJECTOR RUNTIME LAMP1 *1 LAMP2 *1 INTAKE AIR TEMP. OPTICS MODULE TEMP. AROUND LAMP TEMP. REMAINING FILTER QUANTITY *2 PROJECTOR TYPE SERIAL NUMBER Displays the input selection state. Displays the input signal name. Displays the frequency of the input signal. Displays the projector runtime. Displays the lighting time of LAMP1. Displays the lighting time of LAMP2. Displays the intake air temperature of the projector. Displays the temperature inside the projector. Displays the temperature around the lamp of the projector. Displays the filter remaining quantity. Displays type of projector. Displays the serial number of the projector. LAMP UNIT MODEL NO. LAMP1 SERIAL NUMBER LAMP2 SERIAL NUMBER MAIN VERSION SUB VERSION NETWORK VERSION EMULATE ON COUNT LAMP1 LAMP2 NUMBER OF ENTRY SIGNAL REMOTE2 STATUS AC VOLTAGE Displays the component number of the lamp unit. Displays the serial number for lamp1. Displays the serial number for lamp2. Displays the main version of the firmware of the projector unit. Displays the sub version of the firmware of the projector unit. Displays the network version of the projector unit. Displays the set emulate mode. zzPOWER ON TIMES : Displays the number of times the power has been turned on. zzLAMP1 ON : Displays the number of times LAMP1 has been lit. zzLAMP2 ON : Displays the number of times LAMP2 has been lit. Displays the lighting time of LAMP1. (HIGH or LOW) Displays the lighting time of LAMP2. (HIGH or LOW) Displays the number of registered signals. Displays [REMOTE 2 IN] control status. Displays the AC voltage state. ***** Lamp replacement time = LAMP POWER [HIGH] lighting time + (LAMP POWER [LOW] lighting time x 3 ÷ 4) ***** REMAINING FILTER QUANTITY If the remaining quantity of ACF becomes 8%, the status display turns yellow. If the remaining quantity becomes 0%, the display turns red. If the residual filter indication becomes yellow, the remaining usable time is about 200 hours. The time of 200 hours is for reference only. It depends on the usage environment. Settings ENGLISH - 83