Panasonic PTDW8300U PTDS8500U User Guide - Page 20
Setting projector ID number to remote control, Using a wired remote control
UPC - 885170011014
View all Panasonic PTDW8300U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Preparation About Your Projector Setting projector ID number to remote control Each projector can be assigned a unique ID number, and the handheld remote' s number must be set to match the intended projector. The ID number of the projector is set to "ALL" on shipping, and use the ID ALL button of the remote control when using only a single projector. 1111 Press button, and the projector (s) will display it's current ID number onscreen. Within 5 seconds, use the numeric keys (0-9) to match the Remote's ID number with that of the desired projector. Attention zzDo not press button accidentally or carelessly because the ID number on the remote control can be set even when no projector is around. zzIf you do not enter the 2 digits ID number within 5 seconds after button has been pressed, the ID will remain at the number that was set before button was pressed. zzYour specified ID number is stored in the remote control unit unless another one is specified later. However, the stored ID will be erased if the batteries of the remote control are left exhausted. When the batteries are replaced, set the same ID number again. zzThe ID number can be set to "ALL" or from "1" to "64". Note zzRefer to "PROJECTOR ID" of "PROJECTOR SETUP menu" (Æpage 75). Using a wired remote control When multiple projectors are connected as part of the system, connect to units with a M3 stereo mini jack commercial cable to simultaneously control multiple main units with a single remote control through the REMOTE 1 IN/OUT terminal. It is effective to use the wired remote control in the environment in which an obstacle stands in the light path or where devices are susceptible to outside light. Connect to the remote control wired terminal Remote Control M3 stereo mini jack cable (commercial) Connect to the secondary projector Connection terminals Attention zzUse 2 core shielded cable of length of 15 m or less. If the length of the cable exceeds 15 m (49' 2"), the shielding of the cable may not be sufficient and the remote control may not work. 20 - ENGLISH