Panasonic RXEX1 RXEX1 User Guide - Page 13

1 PGM FADER SLEEP REC RANDOM EQ ON ALL1-REC ST MONO 1 PGM FADER SLEEP REC RANDOM EQ ON ALL1-REC ST MONO 1 PGM FADER SLEEP REC RANDOM EQ ON ALL1-REC ST MONO 1 PGM FADER SLEEP REC RANDOM EQ ON ALL1-REC ST MONO Auto scan 1 PGM FADER SLEEP REC RANDOM EQ ON ALL 1-REC MONO FM 1 PGM FADER SLEEP REC RANDOM AM EQ ON ALL 1-REC MONO 4 5 6 10 7 8 9 0 AUTO SCAN C-RESET FM MODE BP CD PLAY MODE CLOCK TIMER TAPE TUNER CD P 1 PGM FADER SLEEP REC RANDOM EQ ON ALL1-REC ST MONO The Radio: manual tuning Press [POWER, ] to turn the unit on. Press [TUNER BAND] to select FM or AM. Each time the button is pressed: AM FM Press [TUNE MODE] to select the manual tuning mode. Make sure that " " is not displayed. Press [REW/-/ ] or [ /+/FF] to select a station. " " is displayed during FM stereo broadcasts. Turn [- "VOLUME#+] to adjust the volume. Auto-tuning Press and hold [REW/-/ ] or [ /+/FF] until the frequency starts changing rapidly. Stops when it finds a station. (Interference may also cause it to stop. Start auto-tuning again if this occurs.) To stop auto-tuning Press [REW/-/ ] or [ /+/FF]. Using auto scan Remote control only You can search for a station by listening to all tuned-in stations for 8 seconds each. s1 Press [TUNER] to select "FM" or "AM". s2 Press [AUTO SCAN]. Auto scan starts. s3 Press [AUTO SCAN] when you find the desired station. Auto scan ends when it reaches the original frequency again. To stop during the process, press [AUTO SCAN]. To improve reception FM: Change the length and position of the antenna. AM: Change the facing of the unit. •AM reception is briefly interrupted if a tape deck is operated. •To improve reception when using the unit in a building or vehicle use it near a window. If noise is excessive in FM Remote control only Press [FM MODE/BP] to display " MONO ". Monaural sound is selected (" " goes off) and noise reduces when reception is weak. Press [FM MODE/BP] again to cancel the mode. To receive FM broadcasts allocated in 0.1MHz Main unit only First press [TUNER BAND] to select "AM". Now, press and hold [TUNER BAND]. The display changes in a few seconds to show the current lowest FM frequency. Continue to hold down the button. The minimum frequency changes and the step is changed at 13 the same time. Changing the step erases all preset stations. Repeat the above to change the step back. RQT5671 Listening